PIC24FJ256DA206-IPT Datasheet, PDF (5/20 Pages) Microchip Technology – 16-bit Embedded Control Solutions PIC24 Microcontrollers • dsPIC® Digital Signal Controllers

Flexible Integrated Peripherals
PIC24 & dsPIC DSC Family Block Diagram
4-512 KB 512B-96 KB 0-512B
Flash
RAM
EEPROM
DMA
USB On-the-Go
ADC 10-bit, 16 ch.
CTMU
ADC - 2, 10/12-bit, 32 ch.
M_Me_em_mo_orr_yy _BB_uu_ss
Op Amp/Analog Comp., 0-4
Watchdog & PWR Mgmt.
CAN, 0-2
32-bit CRC, GP I/O
16/40/70 MIPS 16-bit Core
16-bit ALU
Register File
16 x 16
Interrupt
Control
Input Capture
Out Comp./PWM
SPI, 1-4
16/32-bit Timers
UART, 1-4
I²C™, 1-3
17 x 17
MPY
Address
Generation
PMP
CRC
JTAG & Emul.
Barrel
RTCC
Interface
Shifter
DSBOR
PMP
LCD
Segment
Drive
Integrated Graphics
Graphics
Acceleration Units
Display Controller
Color Lookup Table
DSWDT
INT0
VBAT
Digital I/O
■■   Peripheral Pin Select (PPS)
•    Remap digital I/O
•    Supports most digital peripherals
■■   Up to 122 programmable digital I/O pins
■■   Wake-up/Interrupt-on-change on up to
52 pins
■■   High current sink/source
Communication Modules
■■   3-wire SPI: up to 3 modules
•    Framing supports I/O interface to
simple codecs
■■   I²C™: up to 3 modules
•    Full multi-master and Slave mode
support
•    7-bit and 10-bit addressing
■■   UART: up to 4 modules
•    Interrupt-on-address bit detect
•    Wake-up on Start bit from Sleep mode
•    4-character TX and RX FIFO buffers
•    LIN and IrDA support
■■   USB Device, Host & OTG
•    Internal Boost Regulator requires
minimal external components
•    Separate 3.3V regulator
•    Transparent RAM buffer interface
■■   CAN 2.0 (up to 2 modules)
Digital Power Peripherals
■■   10-bit ADC Up to 4 Msps, Up to 6
sample and holds
■■   PS PWM, 1 nS duty cycle resolution
■■   Analog comparators, 25 ns
■■   Programmable reference
Timers/Capture/Compare/PWM
■■   Timer/counters: up to nine 16-bit timers
•    Can pair up to make 32-bit timers
•    1 timer can run as real-time clock
■■   Input capture: up to 16 channels
•    Capture on rising, falling or both edges
•    4-deep FIFO on each capture
■■   Output compare: up to 16 channels
•    Dedicated timer
•    Single or dual 16-bit compare mode
•    16-bit glitchless PWM mode
Auxilary Functions
■■   LCD Segment Driver:
•    60 Segment × 8 Common Driver
■■   Graphics Controller Features:
•    3× graphics hardware acceleration units
•   Color look-up table with up to 256 entries
•    Direct interface to monochrome,
C-STN, TFT, OLED
■■   Parallel Master Slave Port (PMP/PSP):
•    Communicates with external
data memory, communications
peripherals, LCDs
•    Supports 8-bit or 16-bit data
•    Supports 16 address lines
■■   Hardware Real-Time Clock/Calendar (RTCC):
•    Provides clock, calendar and
alarm functions
■■   Programmable CRC generator
■■   Charge time measurement unit (CTMU)
•    Capacitive touch sense keypad I/F
•    Provides 1 ns resolution time
measurements
•    Temperature Sensing
■■   Peripheral Trigger Generator (PTG)
Analog Subsystems
■■   On-chip high speed op amps
•    Up to 10 MHz gain bandwidth
■■   Analog comparators (up to 4):
•    Programmable reference
■■   ADC
•    10-bit up to 1.1 Msps, 4 S&H
•    12-bit up to 500 ksps, 1 S&H
•    Configurable 10/12-bit options
•    Buffered outputor DMA
•    Autoscanning
•    Supports CVD touch
Motor Control Peripherals
■■   Motor Control PWM: up to 14 outputs
•    Up to 7 duty cycle generators
•    Independent or complementary mode
•    Programmable dead time settings
•    Edge or center-aligned PWMs
•    Manual output override control
•    Up to 10 fault inputs
•    ADC samples triggered by PWM module
■■   Quadrature encoder interface module
•    Up to 2 modules
•    Phase A, Phase B and index pulse input
■■   High current sink/source
16-bit Embedded Control Solutions 5