24C65 Datasheet, PDF (3/24 Pages) Microchip Technology – 64K 5.0V I 2 C Smart Serial EEPROM

24AA65/24LC65/24C65
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings^(†)
VCC............................................................................................................................................................................. 7.0V
All inputs and outputs w.r.t. VSS ..........................................................................................................-0.6V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied................................................................................................-40°C to +125°C
ESD protection on all pins ......................................................................................................................................................≥ 4 kV
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above those
indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for an
extended period of time may affect device reliability.
TABLE 1-1: DC CHARACTERISTICS
DC CHARACTERISTICS
VCC = +1.8V to +6.0V
Commercial (C): TA =
Industrial
(I): TA =
Automotive (E): TA =
0°C to +70°C
-40°C to +85°C
-40°C to +125°C
Parameter
Sym
A0, A1, A2, SCL and SDA pins:
High-level input voltage
VIH
Low-level input voltage
VIL
Hysteresis of Schmitt Trigger inputs VHYS
Low-level output voltage
VOL
Input leakage current
ILI
Output leakage current
ILO
Pin capacitance
(all inputs/outputs)
CIN, COUT
Operating current
ICC Write
ICC Read
Standby current
ICCS
Min
.7 VCC
—
.05 VCC
—
—
—
—
—
—
—
Max
—
.3 VCC
—
.40
±1
±1
10
3
150
5
Note 1: This parameter is periodically sampled and not 100% tested.
Units
Conditions
V
V
V (Note 1)
V IOL = 3.0 mA
μA VIN = .1V to VCC
μA VOUT = .1V to VCC
pF VCC = 5.0V (Note 1)
TA = 25°C, FCLK = 1 MHz
mA VCC = 6.0V, SCL = 400 kHz
μA VCC = 6.0V, SCL = 400 kHz
μA VCC = 5.0V, SCL = SDA = VCC
A0, A1, A2 = VSS
FIGURE 1-1:
BUS TIMING START/STOP
VHYS
SCL
SDA
TSU:STA
THD:STA
TSU:STO
Start
Stop
© 2008 Microchip Technology Inc.
DS21073K-page 3