|
24C01B Datasheet, PDF (3/13 Pages) Microchip Technology – 1K/2K 5.0V I 2 C ™ Serial EEPROM | |||
|
◁ |
24C01B/02B
TABLE 1-2: AC CHARACTERISTICS
All Parameters apply across the
speciï¬ed operating ranges unless
otherwise noted
Vcc = 4.5V to 5.5V
Automotive (E): Tamb = -40ËC to +125ËC,
Parameter
Symbol Min. Max. Units
Remarks
Clock frequency
FCLK
â
100 kHz
Clock high time
THIGH
4000
â
ns
Clock low time
TLOW
4700
â
ns
SDA and SCL rise time
TR
â
1000 ns (Note 1)
SDA and SCL fall time
TF
â
300
ns (Note 1)
START condition hold time
THD:STA 4000
â
ns After this period the ï¬rst clock pulse is
generated
START condition setup time
TSU:STA 4700
â
ns Only relevant for repeated
START condition
Data input hold time
THD:DAT
0
â
ns (Note 2)
Data input setup time
TSU:DAT
250
â
ns
STOP condition setup time
TSU:STO 4000
â
ns
Output valid from clock
TAA
â
3500 ns (Note 2)
Bus free time
TBUF
4700
â
ns Time the bus must be free before a new
transmission can start
Output fall time from VIH
minimum to VIL maximum
TOF
â
250
ns (Note 1), CB ⤠100 pF
Input ï¬lter spike suppression
TSP
â
50
ns (Note 3)
(SDA and SCL pins)
Write cycle time
TWR
â
10
ms Byte or Page mode
Endurance
â
1M
â cycles 25°C, Vcc = 5.0V, Block Mode (Note 4)
Note 1: Not 100% tested. CB = total capacitance of one bus line in pF.
2: As a transmitter, the device must provide an internal minimum delay time to bridge the undeï¬ned region
(minimum 300 ns) of the falling edge of SCL to avoid unintended generation of START or STOP conditions.
3: The combined TSP and VHYS speciï¬cations are due to Schmitt trigger inputs which provide improved noise
spike suppression. This eliminates the need for a TI speciï¬cation for standard operation.
4: This parameter is not tested but guaranteed by characterization. For endurance estimates in a speciï¬c
application, please consult the Total Endurance Model which can be obtained on our BBS or website.
FIGURE 1-2: BUS TIMING DATA
TF
TLOW
THIGH
SCL
TSU:STA
SDA
IN
TSP
THD:STA
THD:DAT
SDA
OUT
TAA
THD:STA
TAA
TR
TSU:DAT
TSU:STO
TBUF
© 1997 Microchip Technology Inc.
Preliminary
DS21233A-page 3
|
▷ |