USB3613 Datasheet, PDF (26/57 Pages) SMSC Corporation – USB 2.0 Hi-Speed 3-Port Hub Controller Optimized for Portable Applications

USB 2.0 Hi-Speed 3-Port Hub Controller Optimized for Portable Applications
Datasheet
6.2.1.6
6.2.2
6.2.2.1
6.2.2.2
6.3
Other Embedded Controller functions over USB
The following miscellaneous functions may be configured via USB:
 Enable/Disable Embedded controller enumeration
 Program Configuration parameters.
 Program descriptor fields:
—Language ID
—Manufacturer string
—Product string
—idVendor
—idProduct
—bcdDevice
SMBus Accessible Functions
OTP Access over SMBus
The device’s OTP ROM is accessible over SMBus. All OTP parameters can modified via the SMbus
Host. The OTP can be programmed to operate in Single-Ended, Differential, Redundant, or Differential
Redundant mode, depending on the level of reliability required. The supported commands are:
 Enable OTP reset
 Set OTP operating mode
 Set OTP read mode
 Program OTP
 Get OTP Status
 Program OTP control parameters
Configuration Access over SMBus
The following functions are available over SMBus prior to the hub attaching to the USB host:
 Program Configuration parameters.
 Program descriptor fields:
—Language ID
—Manufacturer string
—Product string
—idVendor
—idProduct
—bcdDevice
 Program Control Register
Device Configuration Straps
Configuration straps are multi-function pins that are driven as outputs during normal operation. During
a Power-On Reset (POR) or an External Chip Reset (RESET_N), these outputs are tri-stated. The high
or low state of the signal is latched following de-assertion of the reset and is used to determine the
default configuration of a particular feature. Configuration straps are latched as a result of a Power-On
Reset (POR) or a External Chip Reset (RESET_N). Configuration strap signals are noted in Chapter 3,
DS00001714A-page 26
 2014 Microchip Technology Inc.