93C76 Datasheet, PDF (2/12 Pages) Microchip Technology – 8K/16K 5.0V Microwire Serial EEPROM

93C76/86
1.0 ELECTRICAL
CHARACTERISTICS
1.1 Maximum Ratings*
VCC ...................................................................................7.0V
All inputs and outputs w.r.t. VSS ............... -0.6V to Vcc +1.0V
Storage temperature ..................................... -65˚C to +150˚C
Ambient temp. with power applied................. -65˚C to +125˚C
Soldering temperature of leads (10 seconds) ............. +300˚C
ESD protection on all pins................................................4 kV
*Notice: Stresses above those listed under “Maximum ratings”
may cause permanent damage to the device. This is a stress rat-
ing only and functional operation of the device at those or any
other conditions above those indicated in the operational listings
of this specification is not implied. Exposure to maximum rating
conditions for extended periods may affect device reliability
TABLE 1-1: PIN FUNCTION TABLE
Name
CS
CLK
DI
DO
VSS
ORG
PE
VCC
Function
Chip Select
Serial Data Clock
Serial Data Input
Serial Data Output
Ground
Memory Configuration
Program Enable
Power Supply
1.2 AC Test Conditions
AC Waveform:
VLO = 2.0V
VHI = Vcc - 0.2V
VHI = 4.0V for
(Note 1)
(Note 2)
Timing Measurement Reference Level
Input
0.5 VCC
Output
0.5 VCC
Note 1: For VCC ≤ 4.0V
2: For VCC > 4.0V
TABLE 1-2: DC CHARACTERISTICS
Applicable over recommended operating ranges shown below unless otherwise noted:
VCC = +4.5V to +5.5V
Commercial (C): Tamb = 0°C to -40°C
Industrial (I):
Tamb = -40°C to +85°C
Automotive (E): Tamb = -40°C to +125°C
Parameter
Symbol
Min.
Max.
Units Conditions
High level input voltage VIH1
2.0
VCC +1
V
Low level input voltage
VIL1
-0.3
0.8
V
Low level output voltage VOL1
—
0.4
V
VOL2
—
0.2
V
High level output voltage VOH1
2.4
—
V
VOH2
VCC-0.2
—
V
Input leakage current
ILI
-10
10
µA
Output leakage current ILO
-10
10
µA
Pin capacitance
(all inputs/outputs)
CINT
—
7
pF
Operating current
ICC write
—
3
mA
ICC read
—
1.5
mA
Standby current
ICCS
—
100
µA
Note: This parameter is periodically sampled and not 100% tested.
—
—
IOL = 2.1 mA; VCC = 4.5V
IOL =100 µA; VCC = 4.5V
IOH = -400 µA; VCC = 4.5V
IOH = -100 µA; VCC = 4.5V.
VIN = 0.1V to VCC
VOUT = 0.1V to VCC
(Note Note:)
Tamb = +25˚C, FCLK = 1 MHz
FCLK = 2 MHz; VCC = 5.5V
FCLK = 2 MHz; VCC = 5.5V
CLK = CS = 0V; VCC = 5.5V
DS21132C-page 2
Preliminary
© 1996 Microchip Technology Inc.