24AA512_05 Datasheet, PDF (2/26 Pages) Microchip Technology – 512K I2C™ CMOS Serial EEPROM

24AA512/24LC512/24FC512
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings ^(†)
VCC.............................................................................................................................................................................6.5V
All inputs and outputs w.r.t. VSS ......................................................................................................... -0.6V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied ................................................................................................-40°C to +125°C
ESD protection on all pins ......................................................................................................................................................≥ 4 kV
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above those
indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for
extended periods may affect device reliability.
TABLE 1-1: DC CHARACTERISTICS
DC CHARACTERISTICS
Electrical Characteristics:
Industrial (I): VCC = +1.8V to 5.5V
Automotive (E): VCC = +2.5V to 5.5V
TA = -40°C to +85°C
TA = -40°C to +125°C
Param.
No.
Sym.
Characteristic
Min.
Max. Units
Conditions
D1
—
A0, A1, A2, SCL, SDA
—
and WP pins:
—
——
D2
VIH
High-level input voltage 0.7 VCC
—
V—
D3
VIL
Low-level input voltage
—
0.3 VCC
V VCC ≥ 2.5V
0.2 VCC
V VCC < 2.5V
D4
VHYS Hysteresis of Schmitt
0.05 VCC
—
Trigger inputs
(SDA, SCL pins)
V VCC ≥ 2.5V (Note)
D5
VOL
Low-level output voltage
—
0.40
V IOL = 3.0 ma @ VCC = 4.5V
IOL = 2.1 ma @ VCC = 2.5V
D6
ILI
Input leakage current
—
±1
μA VIN = VSS or VCC, WP = VSS
VIN = VSS or VCC, WP = VCC
D7
ILO
Output leakage current
—
±1
μA VOUT = VSS or VCC
D8
CIN,
Pin capacitance
COUT (all inputs/outputs)
—
10
pF VCC = 5.0V (Note)
TA = 25°C, FCLK = 1 MHz
D9
ICC Read Operating current
—
400
μA VCC = 5.5V, SCL = 400 kHz
ICC Write
—
5
mA VCC = 5.5V
D10 ICCS
Standby current
—
1
μA TA = -40°C to +85°C
SCL = SDA = VCC = 5.5V
A0, A1, A2, WP = VSS
—
5
μA TA = -40°C to +125°C
SCL = SDA = VCC = 5.5V
A0, A1, A2, WP = VSS
Note: This parameter is periodically sampled and not 100% tested.
DS21754G-page 2
© 2005 Microchip Technology Inc.