24AA08H_13 Datasheet, PDF (2/32 Pages) Microchip Technology – 8K I2C™ Serial EEPROM with Half-Array Write-Protect

24AA08H/24LC08BH
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings ^(†)
VCC.............................................................................................................................................................................6.5V
All inputs and outputs w.r.t. VSS ......................................................................................................... -0.3V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied ................................................................................................-40°C to +125°C
ESD protection on all pins  4 kV
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to
the device. This is a stress rating only and functional operation of the device at those or any other conditions
above those indicated in the operational listings of this specification is not implied. Exposure to maximum rating
conditions for extended periods may affect device reliability.
TABLE 1-1: DC CHARACTERISTICS
DC CHARACTERISTICS
VCC = +1.7V to +5.5V
Industrial (I): TA = -40°C to +85°C
Automotive (E): TA = -40°C to +125°C
Param.
No.
Symbol
Characteristic
Min.
Typ.
Max. Units
Conditions
—
—
WP, SCL and SDA pins
—
—
—
D1
VIH
High-level input voltage 0.7 VCC
—
—
D2
VIL
Low-level input voltage
—
—
0.3 VCC
D3
VHYS
Hysteresis of Schmitt
0.05 VCC —
—
Trigger inputs
D4
VOL
Low-level output voltage
—
—
0.40
D5
ILI
Input leakage current
—
—
±1
D6
ILO
Output leakage current —
—
±1
D7
CIN,
Pin capacitance
COUT (all inputs/outputs)
—
—
10
D8
ICC write Operating current
—
0.1
3
D9
ICC read
—
0.05
1
D10 ICCS
Standby current
—
0.01
1
—
—
5
Note: This parameter is periodically sampled and not 100% tested.
——
V—
V—
V (Note)
V IOL = 3.0 mA, VCC = 2.5V
A VIN = VSS or VCC
A VOUT = VSS or VCC
pF VCC = 5.0V (Note)
TA = 25°C, FCLK = 1 MHz
mA VCC = 5.5V, SCL = 400 kHz
mA —
A Industrial
A Automotive
SDA = SCL = VCC
WP = VSS
DS20002084B-page 2
 2008-2013 Microchip Technology Inc.