24AA014_10 Datasheet, PDF (2/36 Pages) Microchip Technology – 1K I2C™ Serial EEPROM

24AA014/24LC014
1.0 ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings ^(†)
VCC.............................................................................................................................................................................6.5V
All inputs and outputs w.r.t. VSS ......................................................................................................... -0.6V to VCC +1.0V
Storage temperature ...............................................................................................................................-65°C to +150°C
Ambient temperature with power applied ................................................................................................-40°C to +125°C
ESD protection on all pins  4 kV
† NOTICE: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above those
indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for
extended periods may affect device reliability.
TABLE 1-1: DC SPECIFICATIONS
DC CHARACTERISTICS
Industrial (I): TA = -40°C to +85°C, VCC = +1.7V to +5.5V
Automotive (E): TA = -40°C to +125°C, VCC = +2.5V to +5.5V
Param.
No.
Symbol
Characteristic
Min.
Typ.
Max. Units
Conditions
—
A0, A1, A2, SCL, SDA
—
—
—
and WP pins
D1
VIH
High-level input voltage 0.7 VCC
—
—
D2
VIL
Low-level input voltage
—
—
0.3 VCC
D3
VHYS
Hysteresis of Schmitt
0.05 VCC —
—
Trigger inputs
D4
VOL
Low-level output voltage
—
—
0.40
D5
ILI
Input leakage current
—
—
±1
D6
ILO
Output leakage current
—
—
±1
D7
CIN,
Pin capacitance
COUT (all inputs/outputs)
—
—
10
D8
ICC write Operating current
—
0.1
3
D9
ICC read
—
0.05
1
D10 ICCS
Standby current
—
0.01
1
—
—
5
Note: This parameter is periodically sampled and not 100% tested.
——
V—
V 0.2 VCC for VCC < 2.5V
V (Note)
V IOL = 3.0 mA, VCC = 2.5V
A VIN = VSS or VCC
A VOUT = VSS or VCC
pF VCC = 5.5V (Note)
TA = 25°C, FCLK = 1 MHz
mA VCC = 5.5V, SCL = 400 kHz
mA —
A Industrial
A Automotive
SDA = SCL = VCC
A0, A1, A2, WP = VSS
DS21809G-page 2
 2010 Microchip Technology Inc.