KSZ8895MQX Datasheet, PDF (17/108 Pages) Microchip Technology – Integrated 5-Port 10/100 Managed Ethernet Switch with MII/RMII Interface

KSZ8895MQX/RQX/FQX/MLX
The KSZ8895MQX/RQX/FQX/MLX can function as a managed switch or an unmanaged switch. If no EEPROM or
micro-controller exists, then the KSZ8895MQX/RQX/FQX/MLX will operate from its default setting. The strap-in option
pins can be configured by external pull-up/down resistors and take effect after power down reset or warm reset. The
functions are described in the table below.
TABLE 2-2:
Pin Number
1
62
63
64
65
66
67
68
80
81
82
STRAP-IN OPTIONS - KSZ8895MQX/RQX/FQX/MLX
Pin Name
Type,
Note 2-3
Description, Note 2-4
MDI-XDIS
PMRXD3
PMRXD2
PMRXD1
PMRXD0
PMRXER
PCRS
PCOL
SMRXD3
SMRXD2
SMRXD1
IPD
IPD/O
IPD/O
IPD/O
IPD/O
IPD/O
IPD/O
IPD/O
IPD/O
IPD/O
IPD/O
Disable auto MDI/MDI-X.
Strap option:
PD = (default) = normal operation.
PU = disable auto MDI/MDI-X on all ports.
PHY [5] MII receive bit 3.
Strap option:
PD (default) = enable flow control;
PU = disable flow control.
PHY [5] MII receive bit 2.
Strap option:
PD (default) = disable back pressure;
PU = enable back pressure.
PHY [5] MII/RMII receive bit 1.
Strap option:
PD (default) = drop excessive collision packets;
PU = does not drop excessive collision packets.
PHY [5] MII/RMII receive bit 0.
Strap option:
PD (default) = disable aggressive back-off algorithm in half-duplex
mode;
PU = enable for performance enhancement.
PHY [5] MII/RMII receive error.
Strap option:
PD (default) = 1522/1518 bytes;
PU = packet size up to 1536 bytes.
PHY [5] MII carrier sense
Strap option for Port 4 only
PD (default) = force half-duplex if auto-negotiation is disabled or
fails.
PU = force full-duplex if auto-negotiation is disabled or fails. Refer to
Register 76.
PHY [5] MII collision detect
Strap option for Port 4 only.
PD (default) = no force flow control.
PU = force flow control. Refer to Register 66.
Switch MII receive bit 3.
Strap option:
PD (default) = disable switch SW5-MII/RMII full-duplex flow control;
PU = enable switch SW5-MII/RMII full-duplex flow control.
Switch MII receive bit 2.
Strap option:
PD (default) = switch SW5-MII/RMII in full-duplex mode;
PU = switch SW5-MII/RMII in half-duplex mode.
Switch MII/RMII receive bit 1
Strap option:
PD (default) = switch SW5-MII/RMII in 100 Mbps mode.
PU = switch MII/RMII in 10 Mbps mode.
 2016 Microchip Technology Inc.
DS00002246A-page 17