PIC24HJXXXGPX06A Datasheet, PDF (157/294 Pages) Microchip Technology – High-Performance, 16-Bit Microcontrollers

PIC24HJXXXGPX06A/X08A/X10A
15.0 OUTPUT COMPARE
Note:
This data sheet summarizes the features
of the PIC24HJXXXGPX06A/X08A/X10A
families of devices. It is not intended to be
a comprehensive reference source. To
complement the information in this data
sheet, refer to the “PIC24H Family
Reference Manual”, Section 13. “Output
Compare” (DS70247), which is available
on the Microchip web site
(www.microchip.com).
The output compare module can select either Timer2 or
Timer3 for its time base. The module compares the
value of the timer with the value of one or two Compare
registers depending on the operating mode selected.
The state of the output pin changes when the timer
value matches the Compare register value. The output
compare module generates either a single output
pulse, or a sequence of output pulses, by changing the
state of the output pin on the compare match events.
The output compare module can also generate
interrupts on compare match events.
The output compare module has multiple operating
modes:
• Active-Low One-Shot mode
• Active-High One-Shot mode
• Toggle mode
• Delayed One-Shot mode
• Continuous Pulse mode
• PWM mode without Fault Protection
• PWM mode with Fault Protection
FIGURE 15-1:
OUTPUT COMPARE MODULE BLOCK DIAGRAM
Set Flag bit
OCxIF⁽¹⁾
OCxRS⁽¹⁾
OCxR⁽¹⁾
Comparator
0 1 OCTSEL 0
16
16
Output
Logic
3
OCM<2:0>
Mode Select
1
SQ
R
OCx⁽¹⁾
Output Enable
OCFA
or
OCFB⁽²⁾
TMR2 TMR3
TMR2 _TMR3
Rollover _Rollover
Note 1: An ‘x’ in a signal, register or bit name denotes the number of the output compare channels.
2: The OCFA pin controls OC1 through OC4. The OCFB pin controls OC5 through OC8.
© 2009 Microchip Technology Inc.
Preliminary
DS70592A-page 155