PIC16LV5X Datasheet, PDF (11/24 Pages) Microchip Technology – EPROM-Based 8-Bit CMOS Microcontroller Series

Enhanced PIC16LV5X
5.2 DC Characteristics: PIC16LV5XA-02 (Commercial)
PIC16LV5XA-02 (Industrial)
DC Characteristics
All Pins Except
Power Supply Pins
Standard Operating Conditions (unless otherwise specified)
Operating Temperature 0°C ≤ TA ≤ +70°C (commercial)
–20°C ≤ TA ≤ +85°C (industrial)
Operating Voltage VDD range is described in Section 10.1, Section 10.2 and
Section 10.3 of the Enhanced PIC16C5X data sheet (DS30236B).
Characteristic
Sym Min
Typ⁽¹⁾
Max Units
Conditions
Input Low Voltage
VIL
I/O ports
VSS
MCLR (Schmitt Trigger)
VSS
T0CKI (Schmitt Trigger)
VSS
OSC1 (Schmitt Trigger)
VSS
OSC1
VSS
0.2 VDD
0.15 VDD
0.15 VDD
0.15 VDD
0.3 VDD
V Pin at hi-impedance
V
V
V RC option only⁽⁴⁾
V XT and LP options
Input High Voltage
I/O ports
MCLR (Schmitt Trigger)
T0CKI (Schmitt Trigger)
OSC1 (Schmitt Trigger)
OSC1
VIH
0.2 VDD+1V
0.85 VDD
0.85 VDD
0.85 VDD
0.7 VDD
VDD
V For all VDD⁽⁵⁾
VDD
V
VDD
V
VDD
V RC option only⁽⁴⁾
VDD
V XT and LP options
Hysteresis of Schmitt
Trigger inputs
VHYS 0.15VDD*
Input Leakage Current⁽³⁾ IIL
I/O ports
-1.0
0.5
MCLR
T0CKI
OSC1
-5.0
0.5
-3.0
0.5
-3.0
0.5
V
+1.0
+5.0
+3.0
+3.0
µA VSS ≤ VPIN ≤ VDD,
Pin at hi-impedance
µA VPIN = VSS +0.25V⁽²⁾
µA VPIN = VDD⁽²⁾
µA VSS ≤ VPIN ≤ VDD
µA VSS ≤ VPIN ≤ VDD,
XT and LP options
Output Low Voltage
VOL
I/O ports
OSC2/CLKOUT
0.6
V IOL = 8.7 mA, VDD = 3.8V
0.6
V IOL = 1.6 mA, VDD = 3.8V,
RC option only
Output High Voltage
I/O ports⁽³⁾
OSC2/CLKOUT
VOH
VDD-0.7
VDD-0.7
V IOH = -5.4 mA, VDD = 3.8V
V IOH = -1.0 mA, VDD = 3.8V,
RC option only
* These parameters are characterized but not tested.
Note 1: Data in the Typical (“Typ”) column is based on characterization results at 25°C. This data is for design guidance
only and is not tested.
2: The leakage current on the MCLR/VPP pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltage.
3: Negative current is defined as coming out of the pin.
4: For the RC option, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16LV5X be driven with external clock in RC mode.
5: The user may use the better of the two specifications.
© 1996 Microchip Technology Inc.
Advanced Information
DS40121A-page 11