TC1413_13 Datasheet, PDF (1/18 Pages) Microchip Technology – 3A High-Speed MOSFET Drivers

TC1413/TC1413N
3A High-Speed MOSFET Drivers
Features
• Latch-Up Protected: Will Withstand 500 mA
Reverse Current
• Input Will Withstand Negative Inputs Up to 5V
• ESD Protected: 4 kV
• High Peak Output Current: 3A
• Wide Input Supply Voltage Operating Range:
- 4.5V to 16V
• High Capacitive Load Drive Capability:
- 1800 pF in 20 nsec
• Short Delay Time: 35 nsec Typ
• Matched Delay Times
• Low Supply Current
- With Logic ‘1’ Input: 500 µA
- With Logic ‘0’ Input: 100 µA
• Low Output Impedance: 2.7
• Available in Space-Saving 8-pin MSOP Package
• Pinout Same as TC1410/TC1411/TC1412
Applications
• Switch Mode Power Supplies
• Line Drivers
• Pulse Transformer Drive
• Relay Driver
Package Type
8-Pin MSOP/PDIP/SOIC
V_DD 1
IN 2 _TC1413
NC 3
GND 4
8 V_DD
7 OUT
6 OUT
5 GND
V_DD 1
8 V_DD
IN 2
7 OUT
TC1413N
NC 3
6 OUT
GND 4
5 GND
2
6,7
2
6,7
Inverting
Non-Inverting
NC = No Internal Connection
NOTE: Duplicate pins must be connected together
for proper operation.
General Description
The TC1413/TC1413N are 3A CMOS buffers/drivers.
They will not latch-up under any conditions within their
power and voltage ratings. They are not subject to
damage when up to 5V of noise spiking of either
polarity occurs on the ground pin. They can accept,
without damage or logic upset, up to 500 mA of current
of either polarity being forced back into their output. All
terminals are fully protected against up to 4 kV of
electrostatic discharge.
As MOSFET drivers, the TC1413/TC1413N can easily
charge an 1800 pF gate capacitance in 20 nsec with
matched rise and fall times, and provide low enough
impedance in both the ON and the OFF states to
ensure the MOSFET’s intended state will not be
affected, even by large transients. The leading and
trailing edge propagation delay times are also matched
to allow driving short-duration inputs with greater
accuracy.
 2001-2012 Microchip Technology Inc.
DS21392D-page 1