TC1047_06 Datasheet, PDF (1/12 Pages) Microchip Technology – High Current Charge Pump DC-to-DC Converter

TC962
High Current Charge Pump DC-to-DC Converter
Features:
• Pin Compatible With TC7662/ICL7662/SI7661
• High Output Current 80 mA
• No External Diodes Required
• Wide Operating Range 3V to 18V
• Low Output Impedance 28Ω Typ.
• No Low Voltage Terminal Required
• Application Zener On-Chip
• OSC Frequency Doubling Pin Option for Smaller
Output Capacitors
Applications:
• Laptop Computers
• Disk Drives
• Process Instrumentation
• μP-Based Controllers
Device Selection Table
Part
Number
Package
Operating
Temp.
Range
TC962COE 16-Pin SOIC Wide 0°C to +70°C
TC962CPA 8-Pin Plastic DIP 0°C to +70°C
TC962EPA 8-Pin Plastic DIP -40°C to +85°C
TC962IJA
8-Pin CERDIP -25°C to +85°C
TC962MJA 8-Pin CERDIP -55°C to +125°C
General Description:
The TC962 is an advanced version of the industry
standard TC7662 high voltage DC-to-DC converter.
Using improved design techniques and CMOS
construction, the TC962 can source as much as 80 mA
versus the 7662’s 20 mA capability.
As an inverter, the TC962 can put out voltages as high
as 18V and as low as 3V without the need for external
diodes. The output impedance of the device is a low
28Ω (with the proper capacitors), voltage conversion
efficiency is 99.9%, and power conversion efficiency is
97%.
The low voltage terminal (pin 6) required in some
TC7662 applications has been eliminated. Grounding
this terminal will double the oscillator frequency from 12
kHz to 24 kHz. This will allow the use of smaller
capacitors for the same output current and ripple, in
most applications. Only two external capacitors are
required for inverter applications. In the event an
external clock is needed to drive the TC962 (such as
paralleling), driving this pin directly will cause the
internal oscillator to sync to the external clock.
Pin 1, which is used as a test pin on the 7662, is a
voltage reference Zener on the TC962. This Zener (6.4V
at 5 mA) has a dynamic impedance of 12Ω and is
intended for use where the TC962 is supplying current to
external regulator circuitry and a reference is needed for
the regulator circuit. (See Section 3.0 “Applications
Information” Applications Information).
The TC962 is compatible with the LTC1044, SI7661
and ICL7662. It should be used in designs that require
greater power and/or less input to output voltage drop.
It offers superior performance over the ICL7660S.
Package Type
16-Pin SOIC Wide
8-Pin DIP
Zener
Cathode
1
8-Pin CERDIP
NC 2
Zener
Cathode ¹ •
C+ 2 ^TC962CPA
GND 3
C– 4
TC962EPA
TC962IJA
TC962MJA
8 V_DD
7 C_OSC
6 FREQ x 2
5 V_OUT
C+ 3
NC 4
GND 5
NC 6
C– 7
TC962COE
16 _VDD
15 NC
14 C_OSC
13 NC
12 FREQ x 2
11 NC
10 V_OUT
NC 8
9 NC
© 2006 Microchip Technology Inc.
DS21484C-page 1