KSZ8893M Datasheet, PDF (56/116 Pages) Micrel Semiconductor – Integrated 3-Port 10/100 Managed Switch with PHYs

Micrel, Inc.
KSZ8893MQL/MBL
MII Management (MIIM) Registers
The MIIM interface is used to access the MII PHY registers defined in this section. The SPI, I²C, and SMI
interfaces can also be used to access some of these registers. The latter three interfaces use a different mapping
mechanism than the MIIM interface.
The “PHYADs” by defaults are assigned “0x1” for PHY1 (port 1) and “0x2” for PHY2 (port 2). Additionally, these
“PHYADs” can be programmed to the PHY addresses specified in bits[7:3] of Register 15 (0x0F): Global Control
13.
The “REGAD” supported are 0x0-0x5, 0x1D and 0x1F.
Register Number
PHYAD = 0x1, REGAD = 0x0
PHYAD = 0x1, REGAD = 0x1
PHYAD = 0x1, REGAD = 0x2
PHYAD = 0x1, REGAD = 0x3
PHYAD = 0x1, REGAD = 0x4
PHYAD = 0x1, REGAD = 0x5
PHYAD = 0x1, 0x6 – 0x1C
PHYAD = 0x1, 0x1D
PHYAD = 0x1, 0x1E
PHYAD = 0x1, 0x1F
PHYAD = 0x2, REGAD = 0x0
PHYAD = 0x2, REGAD = 0x1
PHYAD = 0x2, REGAD = 0x2
PHYAD = 0x2, REGAD = 0x3
PHYAD = 0x2, REGAD = 0x4
PHYAD = 0x2, REGAD = 0x5
PHYAD = 0x2, 0x6 – 0x1C
PHYAD = 0x2, 0x1D
PHYAD = 0x2, 0x1E
PHYAD = 0x2, 0x1F
Description
PHY1 Basic Control Register
PHY1 Basic Status Register
PHY1 Physical Identifier I
PHY1 Physical Identifier II
PHY1 Auto-Negotiation Advertisement Register
PHY1 Auto-Negotiation Link Partner Ability Register
PHY1 Not supported
PHY1 LinkMD Control/Status
PHY1 Not supported
PHY1 Special Control/Status
PHY2 Basic Control Register
PHY2 Basic Status Register
PHY2 Physical Identifier I
PHY2 Physical Identifier II
PHY2 Auto-Negotiation Advertisement Register
PHY2 Auto-Negotiation Link Partner Ability Register
PHY2 Not supported
PHY2 LinkMD Control/Status
PHY2 Not supported
PHY2 Special Control/Status
February 2010
56
M9999-021110-1.6