MIC5841 Datasheet, PDF (4/7 Pages) Micrel Semiconductor – 8-Bit Serial-Input Latched Drivers

MIC5841/5842
CLOCK
DATA IN
STROBE
OUTPUT
ENABLE
OUTN
A
D
B
E
F
C
G
Micrel
Timing Conditions
(T_A = 25°C Logic Levels are V_DD and V_SS)
V_DD = 5V
A. Minimum Data Active Time Before Clock Pulse (Data Set-Up Time) ........................................................................ 75 ns
B. Minimum Data Active Time After Clock Pulse (Data Hold Time) .............................................................................. 75 ns
C. Minimum Data Pulse Width ..................................................................................................................................... 150 ns
D. Minimum Clock Pulse Width .................................................................................................................................... 150 ns
E. Minimum Time Between Clock Activation and Strobe ............................................................................................. 300 ns
F. Minimum Strobe Pulse Width ................................................................................................................................... 100 ns
G. Typical Time Between Strobe Activation and Output Transition ............................................................................. 500 ns
SERIAL DATA present at the input is transferred to the shift register on the logic “0” to logic “1” transition of the CLOCK input
pulse. On succeeding CLOCK pulses, the registers shift data information towards the SERIAL DATA OUTPUT. The SERIAL
DATA must appear at the input prior to the rising edge of the CLOCK input waveform.
Information present at any register is transferred to its respective latch when the STROBE is high (serial-to-parallel conversion).
7 ^{The latches will continue to accept new data as long as the STROBE is held high. Applications where the latches are bypassed}
(STROBE tied high) will require that the ENABLE input be high during serial data entry.
When the ENABLE input is high, all of the output buffers are disabled (OFF) without affecting information stored in the latches
or shift register. With the ENABLE input low, the outputs are controlled by the state of the latches.
MIC5840 Family Truth Table
Serial
Data
Input
H
L
X
Clock
Input
Shift Register Contents
I₁ I₂ I₃ …… I₈
H R₁ R₂ …… R₇
L R₁ R₂ …… R₇
R₁ R₂ R₃ …… R₈
X X X …… X
P₁ P₂ P₃ …… P₈
L = Low Logic Level
H = High Logic Level
X = Irrelevant
P = Present State
R = Previous State
Serial
Data Strobe
Output Input
R₇
R₇
R₈
X
L
P₈
H
Latch Contents
I₁ I₂ I₃ …… I₈
R₁ R₂ R₃ …… R₈
P₁ P₂ P₃ …… P₈
X X X …… X
Output
Enable
L
H
Output Contents
I₁ I₂ I₃ …… I₈
P₁ P₂ P₃ …… P₈
H H H …… H
October 1998
7-45