MIC33030 Datasheet, PDF (10/18 Pages) Micrel Semiconductor – 8MHz 400mA Internal Inductor Buck Regulator with HyperLight Load

Micrel Inc.
Functional Description
VIN
The input supply (VIN) provides power to the internal
MOSFETs for the switch mode regulator along with the
internal control circuitry. The VIN operating range is 2.7V
to 5.5V so an input capacitor, with a minimum voltage
rating of 6.3V, is recommended. Due to the high
switching speed, a minimum 2.2µF bypass capacitor
placed close to VIN and the power ground (PGND) pin is
required. Refer to the layout recommendations for
details.
EN
A logic high signal on the enable pin activates the output
voltage of the device. A logic low signal on the enable
pin deactivates the output and reduces supply current to
0.01µA. The MIC33030 features built-in soft-start
circuitry that reduces in-rush current and prevents the
output voltage from overshooting at start up. Do not
leave the enable pin floating.
SW
The switch (SW) connects directly to one end of the
internal inductor and provides the current path during
switching cycles. The other end of the inductor is
connected to the load, SNS pin and output capacitor. As
the MIC33030 has an internal inductor, this pin is not
routed in most applications.
VOUT
The output pin (VOUT) is the output voltage pin following
the internal inductor. Connect a minimum of 2.2uF
output filter capacitor to this pin.
SNS
The sense (SNS) pin is connected to the output of the
device to provide feedback to the control circuitry. The
SNS connection should be placed close to the output
capacitor. Refer to the layout recommendations for more
details.
AGND
The analog ground (AGND) is the ground path for the
biasing and control circuitry. The current loop for the
signal ground should be separate from the power ground
(PGND) loop. Refer to the layout recommendations for
more details.
MIC33030
FB (Adjustable Output Only)
The feedback pin (FB) allows the regulated output
voltage to be set by applying an external resistor
network. The internal reference voltage is 0.62V and the
recommended value of R2 is 200kΩ. The output voltage
is calculated from the equation below:
V_OUT
=
0.62V⎜⎛
⎝
R1
200kΩ
+ 1⎟⎞
⎠
Figure 1. MIC33030-AYHJ Schematic
PGND
The power ground pin is the ground path for the high
current in PWM mode. The current loop for the power
ground should be as small as possible and separate
from the analog ground (AGND) loop as applicable.
Refer to the layout recommendations for more details.
February 2011
10
M9999-020311-C