English
Language : 

MIC4416_05 Datasheet, PDF (1/10 Pages) Micrel Semiconductor – IttyBitty™ Low-Side MOSFET Driver
MIC4416/4417
Micrel, Inc.
MIC4416/4417
IttyBitty™ Low-Side MOSFET Driver
General Description
The MIC4416 and MIC4417 IttyBitty™ low-side MOSFET
drivers are designed to switch an N-channel enhancement-
type MOSFET from a TTL-compatible control signal in low-
side switch applications. The MIC4416 is noninverting and
the MIC4417 is inverting. These drivers feature short delays
and high peak current to produce precise edges and rapid
rise and fall times. Their tiny 4-lead SOT-143 package uses
minimum space.
The MIC4416/7 is powered from a +4.5V to +18V supply
voltage. The on-state gate drive output voltage is approxi-
mately equal to the supply voltage (no internal regulators or
clamps). High supply voltages, such as 10V, are appropriate
for use with standard N-channel MOSFETs. Low supply
voltages, such as 5V, are appropriate for use with logic-level
N-channel MOSFETs.
In a low-side configuration, the driver can control a MOSFET
that switches any voltage up to the rating of the MOSFET.
The MIC4416 is available in the SOT-143 package and
is rated for –40°C to +85°C ambient temperature range.
Features
• +4.5V to +18V operation
• Low steady-state supply current
50µA typical, control input low
370µA typical, control input high
• 1.2A nominal peak output
3.5Ω typical output resistance at 18V supply
7.8Ω typical output resistance at 5V supply
• 25mV maximum output offset from supply or ground
• Operates in low-side switch circuits
• TTL-compatible input withstands –20V
• ESD protection
• Inverting and noninverting versions
Applications
• Battery conservation
• Solenoid and motion control
• Lamp control
• Switch-mode power supplies
Typical Application
* Siliconix
30mΩ, 7A max.
† Load voltage limited only by
MOSFET drain-to-source rating
Load
Voltage†
+12V
4.7µF
0.1µF
On
Off
MIC4416
3
VS
2
G
4 CTL GND 1
Si9410DY*
N-channel
MOSFET
Low-Side Power Switch
Micrel, Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel + 1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
May 2005
1
MIC4416/4417