MLX90283 Datasheet, PDF (9/10 Pages) Melexis Microelectronic Systems – BLDC Vibration Motor Driver

MLX90283
BLDC Vibration Motor Driver
16 LD Package Information
1.50 BSC
0.75 BSC
INDEX AREA
see note 2
Terminal Tip
SEATING PLANE
0.50 BSC
R0.20
INDEX AREA
see note 2
0.25^+/-0.05
see note 4
Notes:
1. All dimensions are in millimeters.
2. The terminal #1 identifier and terminal numbering
convention shall conform JEDEC publication 95
SPP-002. Details of terminal #1 identifier are
optional, but must be located within the zone
indicated. The terminal #1 identifier may be
marked feature.
3. Depopulation is possible in a symmetrical fashion.
4. Pad length applies to metallized terminal and is
measured between 0.15mm and 0.30mm from the
terminal tip. If the terminal has the optional radius
on the other end of the terminal, the pad length
should not be measured in that radius area.
Marking:
1^st Line : .83
“.” (dot) - used to show the 1^st pin
83 - Name of the device (MLX90283)
2^nd Line : YWW
Y - Year (last digit)
WW - Calendar Week
EXPOSED PAD
1.10^+/-0.10
Hall plate location
6
5
4
0.005
0.019
1
2
3
Notes:
1. All dimensions are in millimeters.
2. Top view is represented. Terminals and exposed
pad are for illustration only.
3. Hall Plate position in X and Y axis relative to
package center
Package line
0.24^+/-0.02
SEATING PLANE
Land Pattern
0.25^+/-0.05
Package line
LD package dimensions - Blue
Corresponding land pattern - Green
Notes:
1. All dimensions are in millimeters.
2. Top view is represented.
Package pads and outline are for reference.
3. Recommended minimal distance to prevent solder bridging.
4. Recommended distance for good solder filleting.
5. To enable thermal and electrical characteristics
enhancement, the Exposed Pad must be connected to the
PCB substrate with solder.
6. Exposed pad land pattern should be extended whenever
possible. Therefore, its width is not limited whereas its
height should respect the minimal distance as mentioned in
note 3.
7. Land pattern based on package supplier’s specification.
3901090283
Rev 001
Page 9 of 10
Datasheet
October/07