PB-1000_11 Datasheet, PDF (4/5 Pages) Mean Well Enterprises Co., Ltd. – 1000W Intelligent Single Output Battery Charger

1000W Intelligent Single Output Battery Charger
PB-1000 series
Function Description of CN100
Pin No. Function Description
1,2 RY13 Relay contact rating(max.) : 30V/1A resistive. ; "Short" when the battery A is full, "Open" when the battery A is still charging.
3,4 RY14 Relay contact rating(max.) : 30V/1A resistive. ; "Short" when the battery B is full, "Open" when the battery B is still charging.
Relay contact rating(max.) : 30V/1A resistive. ; "Short" when the unit is working properly, "Open" when the unit is failure or
5,6 RY15 _{the protection function is activating.}
Temperature sensor comes along with the charger can be connected to the unit to allow temperature compensation of the
7,8 GND / RTH ^{charging voltage.}
If the temperature sensor is not used, the charger still works normally.
Turn the output on and off by electrical or dry contact between pin 10 (RC+) and pin 9(RC-), "Open" : Normal work ,
9,10 RC- / RC+ _{"Short" : Stop charging}
Function Manual
1.Remote Control
The charger can be turned ON/OFF by using the
"Remote Control" function.
Between RC+(pin10) and RC-(pin9)
Charger
SW Open
ON
SW Short
OFF
A
B
Stage 8/3/2
12
34
56
78
9 10
B
A
+
-
Battery B
+
-
Battery A
CN100
1 RY13 RY13 2
RY14 RY14
RY15 RY15
GND RTH
9
10
RC- RC+
SW
2.Two Battery Banks
The charger may be hooked up two battery banks (A and/or B). Connect the battery bank(s) as below. If you are connecting 2 battery banks in the
same time, keep in mind that they must share a common ground.
A
B
Stage 8/3/2
12
34
56
78
9 10
B
A
A
B
Stage 8/3/2
12
34
56
78
9 10
B
A
+
-
Battery A
+
-
Battery B
A
B
Stage 8/3/2
12
34
56
78
9 10
B
A
+
-
Battery B
+
-
Battery A
File Name:PB-1000-SPEC 2011-01-18