MDT10P10_04 Datasheet, PDF (1/16 Pages) Micon Design Technology Corporation – 8-bit micro-controller

MDT10P10
MDT10P10
1. General Description
This EPROM-Based 8-bit micro-controller
uses a fully static CMOS design
technology combines higher speeds and
smaller size with the low power and high
noise immunity.
On chip memory system includes 1.0 K
words of ROM, and 32 bytes of static
RAM.
2. Features
The followings are some of the features on
the hardware and software :
u Fully CMOS static design
u 8-bit data bus
u On chip ROM size :1 K words
u Internal RAM size : 32 bytes
(25 general purpose
registers, 7 special
registers)
u 36 single word instructions
u 14-bit instructions
u 2-level stacks
u Operating voltage : 2.3V ~ 5.5 V
u Operating frequency : 0 ~ 20 MHz
u The most fast execution time is 200 ns
under 20 MHz in all single cycle
instructions except the branch
instructions
u Addressing modes include direct,
indirect and relative addressing modes
u Power-on Reset
u Power edge-detector Reset
u Sleep Mode for power saving
u 8-bit real time clock/counter(RTCC)
with 8-bit programmable prescaler
u 4 types of oscillator can be selected
by programming option (Internal
Capacitor about 10p ):
RC Low cost RC oscillator
LFXT Low frequency crystal
oscillator
XTAL Standard crystal oscillator
HFXT High frequency crystal
oscillator
u 4 oscillator start-up time can be
selected by programming option:
150 µs, 20 ms, 40 ms, 80 ms
u On-chip RC oscillator based Watchdog
Timer(WDT) can be operated freely
u 12 I/O pins with their own independent
direction control
3. Applications
The application areas of this MDT10P10
range from appliance motor control and
high speed automotive to low power
remote transmitters/receivers, pointing
devices,
and
telecommunications
processors, such as Remote controller,
small instruments, chargers, toy,
automobile and PC peripheral … etc.
This specification are subject to be changed without notice. Any latest information
please preview http;//www.mdtic.com.tw P. 1
2004/1 VER 1.2