DS1670 Datasheet, PDF(7/16 Page) Dallas Semiconductor

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

DS1670 Datasheet, PDF (7/16 Pages) Dallas Semiconductor – Portable System Controller

◁

DS1670

The DS1670 nonvolatilizes the external SRAM(s) by write protecting the SRAM(s) and by providing a

back-up power supply in the absence of VCC. When VCC falls below 2.88V (typical), access to the

external SRAM(s) are prohibited by forcing CEOL and CEOH high regardless of the level of CEI , BLE ,

and BHE . Also at this point, the SRAM power supply (VCCO) is switched from VCC to VBAT. Upon power-

up, access is prohibited until the end of tRPU.

EXTERNAL SRAM CHIP ENABLE Table 3

CEI

BHE

BLE

CEOL CEOH

FUNCTION

0 Word Transfer

0 Byte Transfer in upper half of data bus (D15-D8)

1 Byte Transfer in lower half of data bus (D7-D0)

1 External SRAMs disabled

EXTERNAL SRAM INTERFACE (WORD-WIDE) TO THE DS1670 Figure 4

MICROPROCESSOR MONITOR

The DS1670 monitors three vital conditions for a microprocessor: power supply, software execution, and

external override.

First, a precision temperature-compensated reference and comparator circuit monitors the status of VCC.

When an out-of-tolerance condition occurs, an internal power-fail signal is generated which forces the

RST pin to the active state, thus warning a processor-based system of impending power failure. The

power-fail trip point is 2.88V (typical). When VCC returns to an in-tolerance condition upon power-up,

the reset signal is kept in the active state for 250ms (typical) to allow the power supply and

microprocessor to stabilize. Note, however, that if the EOSC bit is set to a logic 1 (to disable the oscillator

during battery-backup mode), the reset signal will be kept in an active state for 250ms plus the startup

time of the oscillator.

The second monitoring function is pushbutton reset control. The DS1670 provides for a pushbutton

switch to be connected to the RST output pin. When the DS1670 is not in a reset cycle, it continuously

monitors the RST signal for a low-going edge. If an edge is detected, the DS1670 will debounce the

7 of 16

▷