MAX1287EKA Datasheet, PDF (6/8 Pages) Maxim Integrated Products – PLASTIC ENCAPSULATED DEVICES

Attachment #1
TABLE II. Pin combination to be tested. 1/ 2/
Terminal A
(Each pin individually
connected to terminal A
with the other floating)
Terminal B
(The common combination
of all like-named pins
connected to terminal B)
1.
All pins except V_PS1 3/
All V_PS1 pins
2.
All input and output pins
All other input-output pins
1/ Table II is restated in narrative form in 3.4 below.
2/ No connects are not to be tested.
3/ Repeat pin combination I for each named Power supply and for ground
(e.g., where V_PS1 is V_DD, V_CC, V_SS, V_BB, GND, +V_S, -V_S, V_REF, etc).
3.4 Pin combinations to be tested.
a. Each pin individually connected to terminal A with respect to the device ground pin(s) connected
to terminal B. All pins except the one being tested and the ground pin(s) shall be open.
b. Each pin individually connected to terminal A with respect to each different set of a combination
of all named power supply pins (e.g., V_SS1, or V_SS2 or V_SS3 or V_CC1, or V_CC2) connected to
terminal B. All pins except the one being tested and the power supply pin or set of pins shall be
open.
c. Each input and each output individually connected to terminal A with respect to a combination of
all the other input and output pins connected to terminal B. All pins except the input or output pin
being tested and the combination of all the other input and output pins shall be open.
R1
REGULATED
HIGH VOLTAGE
SUPPLY
Mil Std 883D
Method 3015.7
Notice 8
TERMINAL C
R2
S1
TERMINAL A
S2
DUT
SHORT
C1
SOCKET
CURRENT
TERMINAL B
PROBE
(NOTE 6)
TERMINAL D
R = 1.5kΩ
C = 100pf