English
Language : 

DG417CJ Datasheet, PDF (4/12 Pages) Maxim Integrated Products – Improved, SPST/SPDT Analog Switches
◁
Improved, SPST/SPDT Analog Switches
ELECTRICAL CHARACTERISTICS—Single Supply
(V+ = +12V, V- = 0V, VL = 5V, GND = 0V, VINH = 2.4V, VINL = 0.8V, TA = +25°C, unless otherwise noted.)
PARAMETER
SYMBOL
CONDITIONS
SWITCH
Analog Signal Range
Drain-Source On-Resistance
DYNAMIC
Turn-On Time
Turn-Off Time
Break-Before-Make Interval
Charge Injection (Note 3)
SUPPLY
VANALOG
RDS(ON)
tON
tOFF
tD
Q
(Note 3)
IS = -10mA, VD = 3.8V, V+ = 10.8V
DG417/DG418, VD = 8V, Figure 2
DG417/DG418, VD = 8V, Figure 2
DG419, RL = 1000Ω, CL = 35pF, Figure 4
CL = 10nF, VGEN = 0V, RGEN = 0V, Figure 5
Positive Supply Current
I+
All channels on or off, V+ = 13.2V,
VL = 5.25V, VIN = 0V or 5V
MIN TYP MAX
(Note 2)
UNITS
0
12
V
40
100
Ω
110
ns
40
ns
60
ns
2
10
pC
-0.0001
µA
Negative Supply Current
I-
All channels on or off, V+ = 13.2V,
VL = 5.25V, VIN = 0V or 5V
-0.0001
µA
Logic Supply Current
IL
All channels on or off, VL = 5.25V,
VIN = 0V or 5V
-0.0001
µA
Ground Current
IGND
All channels on or off, VL = 5.25V,
VIN = 0V or 5V
-0.0001
µA
Note 2: Typical values are for design aid only, are not guaranteed, and are not subject to production testing. The algebraic
convention where the most negative value is a minimum and the most positive value a maximum is used in this data sheet.
Note 3: Guaranteed by design.
Note 4: On-resistance match between channels and flatness is guaranteed only with bipolar-supply operation. Flatness is defined as
the difference between the maximum and the minimum value of on-resistance as measured at the extremes of the specified
analog range.
Note 5: Leakage parameters IS(OFF), ID(OFF), and ID(ON) are 100% tested at the maximum rated hot temperature and guaranteed by
correlation at +25°C.
Note 6: Off-Isolation Rejection Ratio = 20log (VD/VS), VD = output, VS = input to off switch.
Note 7: Between any two switches.
4 _______________________________________________________________________________________
 ▷