English
Language : 

MAX1615 Datasheet, PDF (2/8 Pages) Maxim Integrated Products – High-Voltage, Low-Power Linear Regulators for Notebook Computers
High-Voltage, Low-Power Linear Regulators
for Notebook Computers
ABSOLUTE MAXIMUM RATINGS
IN to GND .................................................................-0.3V to 30V
Terminal Voltages to GND
SHDN to GND ...........................................-0.3V to (VIN + 0.3V)
5/3 to GND ............................................-0.3V to (VOUT + 0.3V)
FB (MAX1616) to GND .........................-0.3V to (VOUT + 0.3V)
OUT to GND...........................................................-0.3V to 30V
OUT Short-Circuit to GND ...............................................30sec
Continuous OUT Current.....................................................40mA
Continuous Power Dissipation (TA = +70°C) (Note 1)
SOT23-5 (derate 7.1mW/°C above +70°C)...................571mW
Operating Temperature Range
MAX161_EUK-T ...............................................-40°C to +85°C
Storage Temperature Range .............................-65°C to +160°C
Lead Temperature (soldering, 10sec) .............................+300°C
Note 1: See Operating Region and Power Dissipation section.
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
ELECTRICAL CHARACTERISTICS
(VIN = 15V, SHDN = VIN, ILOAD = 5µA, TA = TMIN to TMAX, unless otherwise noted. Typical values are at TA = +25°C.) (Note 2)
PARAMETER
Input Voltage Range
Supply Current
Minimum Load Current
SYMBOL
VIN
IIN
CONDITIONS
SHDN = IN, TA = +25°C
SHDN = IN, VIN = 6V to 28V, TA = TMIN to TMAX
MIN TYP MAX UNITS
4
28
V
6.2
8
µA
15
5
µA
Shutdown Supply Current
IIN
SHDN = GND
(shutdown mode)
TA = +25°C
TMIN = TMIN to TMAX
1.5
µA
3
Dropout Supply Current
Output set to 5V,
VIN = 4V
TA = +25°C
70
µA
Output Voltage (MAX1615)
(Note 3)
FB Threshold (MAX1616)
(Note 3)
VFBT
FB Input Current (MAX1616)
Dropout Voltage
Output Current Limit
OUT Reverse Leakage
Current
IFB
∆VDO
ILOAD = 1mA,
TA = +25°C,
VIN = 6V to 28V
ILOAD = 5µA to 30mA,
TA = TMIN to TMAX,
VIN = 6V to 28V
FB = OUT,
VIN = 6V to 28V
VFB = 1.3V
ILOAD = 30mA (Note 4)
VIN = 6V
5/3 = GND
5/3 = OUT
5/3 = GND
5/3 = OUT
TA = +25°C,
ILOAD = 1mA
TA = TMIN to TMAX,
ILOAD = 5µA to 30mA
IN = unconnected, VOUT forced to 5V
3.26 3.33 3.40
4.95 5.05 5.15
V
3.15
3.48
4.75
5.25
1.215 1.240 1.265
V
1.18
1.28
V
-10
12
30
nA
350
mV
100
mA
70
µA
Capacitive Load
Requirements (Note 5)
MAX1615
MAX1616
0.16
µF/mA
0.23
Start-Up Time Response
Rising edge of IN or SHDN to OUT within specifi-
cation limits, RL = 500Ω, COUT = 6.8µF,
VOUT set to 5V
1
ms
Start-Up Overshoot
VOSH
RL = 500Ω, COUT = 10µF within 90% of nominal
output voltage
0.5
%VOUT
2 _______________________________________________________________________________________