61003M Datasheet, PDF (4/4 Pages) Mallory performance club – E-SPARK CONVERSION

FIGURE 4
E-SPARK™ WIRING DIAGRAM USING
OEM PRIMARY RESISTANCE WIRE
MUST USE
SUPRESSOR COIL
WIRE
NOTE: WHEN USING THE UNILITE^®
DISTRIBUTOR WITH A HYFIRE^® OR
OTHER AFTERMARKET AMPLIFIER
BOX, CONNECT DISTRIBUTOR
ACCORDING TO THE AMPLIFIER BOX
DIRECTIONS.
IGNITION COIL
NOTE: A PROMASTER^® COIL IS
SHOWN FOR ILLUSTRATION
PURPOSES. WHEN USING A STOCK
COIL, CONNECT IT IN THE SAME
MANNER SHOWN.
RED
GREEN
OEM PRIMARY
RESISTANCE WIRE
DISTRIBUTOR
(TYPICAL)
DISTRIBUTOR WIRE
HARNESS
BROWN
TO IGNITION SWITCH
FIGURE 5
E-SPARK™ WIRING DIAGRAM
USING BALLAST RESISTOR
MUST USE
SUPRESSOR COIL
WIRE
GROUND TO ENGINE BLOCK
NOTE: WHEN USING THE UNILITE^®
DISTRIBUTOR WITH A HYFIRE^® OR
OTHER AFTERMARKET AMPLIFIER
BOX, CONNECT DISTRIBUTOR
ACCORDING TO THE AMPLIFIER BOX
DIRECTIONS.
IGNITION COIL
NOTE: A PROMASTER^® COIL IS
SHOWN FOR ILLUSTRATION
PURPOSES. WHEN USING A STOCK
COIL, CONNECT IT IN THE SAME
MANNER SHOWN.
MALLORY BALLAST
RESISTOR
PART NO. 700 OR
OEM BALLAST
RED
GREEN
DISTRIBUTOR
(TYPICAL)
DISTRIBUTOR WIRE
HARNESS
BROWN
TO IGNITION SWITCH
GROUND TO ENGINE BLOCK
MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
10601 MEMPHIS AVE. #12, CLEVELAND, OH 44144
216.688.8300
FAX [phone]
FORM 1583M
2/04
Made in U.S.A.
Printed in U.S.A.
4
www.mrgasket.com