60143 Datasheet, PDF (11/12 Pages) Mallory performance club – MSD LS Ignition Control

INSTALLATION INSTRUCTIONS
11
REV LIMIT SOURCE
IGNITION VOLTAGE
ENGINE COOLANT
TEMPERATURE
RECORDINGS
STORAGE SPACE
RECORDING
ROTARY DIAL SELECT
TIME FROM LAUNCH
Indicates which source will be limiting the motor . It will be Key Off
when connected via USB, Launch when the launch wire is activated
or Maximum any other time.
This is the voltage being supplied to the unit. This is also the voltage
being supplied to the coils - so it is important that it remains over 12V
to supply proper power to them.
This is the engine coolant temperature in Celsius or Fahrenheit. It will
display -40°C if the sensor is not connected or open and 130°C if it
is shorted.
Number of recordings stored on the device
Amount of free storage space for the recordings
Indicates if the unit is currently recording a data file
Indicates which timing table is selected with the rotary dial and will
be used for timing control.
Indicates the length of time since the Launch Input was de-activated.
Used for Launch Retard.
ALERTS
FAULTS
Description/Cause
MAP SENSOR FAULT
MAP sensor problem (open or shorted)
BATTERY
Activates if voltage drops below 9V or goes above 18V
ECT SENSOR
Displays -40°C if temp sensor is not connected; the controller will
default it to 50°C in the temperature timing control table
CAM FAULT
RPM is detected but no cam sensor signal is present
CRANK FAULT
Camshaft sensor signal is present, but no engine speed is detected
EEPROM READ ERROR EEPROM data corrupted
EEPROM WRITE ERROR Error writing to EEPROM
FLASH READ ERROR Flash data corrupted
FLASH WRITE ERROR Error writing to flash
FLASH FULL
The flash is out of memory. Data acquisition is stopped. The user
needs to delete recordings
DATA ACQUISITION
The data acquisition buffer is 90% full
BUFFER WARNING
DATA ACQUISITION
The data acquisition buffer is full
BUFFER FULL
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]