English
Language : 

6462 Datasheet, PDF (10/24 Pages) Alpha Wire – Customer Specification
10
INSTALLATION INSTRUCTIONS
If triggering with the Magnetic Pickup:
1.  Make sure the ignition switch is in the "Off" position.
2.  Remove the coil wire from the distributor cap and set
the terminal approximately 1/2" from ground.
3.  Disconnect the MSD magnetic pickup wires from the
distributor.
4. Turn the ignition to the On position. Do not crank the
engine.
5.  With a small jumper wire, short the MSD's Green and
Violet magnetic pickup wires together several times.
Each time you break this short, a spark should jump
from the coil wire to ground. If spark is present, the
ignition is working properly. If there is no spark skip
to step 6 below:
MAGNETIC PICKUP TRIGGER
Figure 9 Checking for Spark with Magnetic
Pickup.
6. If there is no spark:
A. Inspect all of the wiring.
B. Substitute another coil and repeat the test. If there is now spark, the coil is at fault.
C. If there is still no spark, check to make sure there is 12 volts on the small Red wire from the
MSD when the key is in the On position. If 12 volts is not present, find another switched
12 volt source and repeat the test.
D. If, after following the test procedures and inspecting all of the wiring, there is still no
spark, the MSD Ignition is in need of repair. See the Warranty and Service section for
information.
The following wiring diagrams illustrate numerous installations on different vehicles and applications.
If you experience difficulties when installing your MSD, contact our Customer Support Department at
(915) 855-7123 (7 - 6 Mountain time) or e-mail us at:
msdtech@msdignition.com
  MSD SYSTEMS  Installing to Points/Amplifier Style Ignition.
NOTE: On dual point setups, it is recommended
to remove the trailing set of points.
NOTE: Ballast Resistor is not necessary.
NOTE: Remove the coil
terminal wires.The negative
wire connects to MSD White.
The positive wire connects
to MSD Red. The MSD
Orange connects to the
coil positive terminal, Black
connects to the coil negative
terminal.
M S D  •  WWW.MSDPERFORMANCE.COM • (915) 855-7123 • FAX (915) 857-3344