PN88862 Datasheet, PDF (1/4 Pages) Mallory performance club – 6LS-2 Harness for EFI Vehicles

6LS-2 Harness for EFI Vehicles
PN 88862
IMPORTANT: Read instuctions thoroughly before attempting installation.
Parts Included:
1 - Cam Sensor Harness
1 - Crank Sensor Harness
1 - Map Sensor Harness
2 - Coil Simulators
2 - Coil Simulator Clips
1 - Crank Sensor Tool Body
1 - Crank Sensor Tool Blade
2 - 6-32 x .250 Screws
WARNING: Before installing the 6LS-2 Harness, disconnect the battery cables. When disconnecting
the battery cables, always remove the Negative (-) cable first and install it last.
This Harness Kit allows the installation of the MSD 6LS-2 Ignition Controller on LS2 or LS7 based vehicles
equipped with factory EFI systems. The Harness connects inline to factory sensors and provides the 12
volt supply and ground of the Controller.
COIL CONNECTIONS
Note: One of the Coil Simulators has a 3-Pin pigtail. This assembly connects to the passenger side coil
bank.
Disconnect the factory connector from the coil harness (Figure 1). Connect the MSD Coil Simulators inline
with the factory harness. Use the supplied clips to secure the Simulators.
Connect the 3-pin pigtail to the MSD 6LS-2.
Note: The 3-pin harness with the ring lug terminal, part of the MSD
6LS-2 is not used with PN 88862.
TO MSD 6LS-2
FACTORY
HARNESS
TO PN 88862
FROM
MSD
6LS-2
Figure 1 Coil Connections.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]