408-10029 Datasheet, PDF (8/9 Pages) Tyco Electronics – Reasons for reissue are provided in Section 8, REVISION SUMMARY.

PIDG and PLASTI- GRIP Terminal and Splice Crimping Heads
408- 10029
7. REPLACEMENT AND REPAIR
Replacement parts and recommended spares are
listed in Figure 9. The recommended spares should
be stocked for immediate replacement.
Order replacement parts through your Tyco
Electronics Representative, or call 1--800--526--5142,
or send a facsimile of your purchase order to
1--717--986--7605, or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105--3608
For further repair and replacement information,
call the Tyco Electronics Tooling Assistance Center at
the number at the bottom of page 1.
8. REVISION SUMMARY
S Updated document to corporate requirements
Detail A
Inspection of Wire Barrel
Crimping Section
Detail B
Inspection of Insulation
Crimping Section
Adjustment
Pins in
Position 1
(Ref)
Wire Barrel Jaws
Bottomed But Not
Under Pressure
8 of 9
Insulation Jaws Bottomed
But Not Under Pressure
GO Element Must Pass
Completely Through the
Crimping Chamber
NO- GO Element May Enter
Partially, But Must Not Pass
Through the Crimping Chamber
Figure 8
Tyco Electronics Corporation
Rev B