V23026 Datasheet, PDF (6/10 Pages) Tyco Electronics – P1 Relay

P1 Relay
V23026
Insulation
Insulation resistance at 500 VDC
Dielectric test voltage (1 min)
between coil and contacts (Relay with 1 coil)
between open contacts
Surge voltage resistance
according to Bellcore TR-NWT-001089 (2 / 10 ms)
between coil and contacts (Relay with 1 coil)
between open contacts
according to FCC 68 (10 / 160 ms)
between coil and contacts (Relay with 1 coil)
between open contacts
Insulation according to IEC / EN 60950
Clearance
Creepage distance
High Frequency Data
Capacitance
between coil and contacts
between open contacts
RF Characteristics
Isolation at 100 / 900 MHz
Insertion loss at 100 / 900 MHz
V.S.W.R. at 100 / 900 MHz
> 10⁹ W
1500 Vrms
500 Vrms
2500 V
on request 2000 V
1500 V
on request 1500 V
Basic insulation
0.75 mm
0.75 mm
max. 6 pF
max. 5 pF
- 30.0 dB / - 18.0 dB
- 0.12 dB / - 1.9 dB
1.06 / 1.75
General data
Operate time at U_nom typ. / max.
Reset time (latching) at U_nom , typ. / max.
Release time without diode in parallel (non-latching), typ. / max.
Release time with diode in parallel (non-latching), typ. / max.
Bounce time at closing contact, typ. / max.
Maximum switching rate without load
Ambient temperature
Thermal resistance
Maximum permissible coil temperature
Vibration resistance (function)
Shock resistance, half sinus, 11 ms
Degree of protection / Environmental protection
Needle flame test
Mounting position
Processing information
Weight (mass)
Terminal surface
Resistance to soldering heat
All data refers to 23° C unless otherwise specified.
1 ms / 2 ms
1 ms / 2 ms
0.4 ms / 1 ms
1.2 ms / 2 ms
1 ms / 3 ms
200 operations/s
-40° C ... +70° C, +85° C on request
< 130 K/W
85° C
20 G, 200 to 2000 Hz
40 G, 10 to 200 Hz
50 G (function)
immersion cleanable, IP 67 / RT III
application time 20 s, burning time < 15 s
any
Ultrasonic cleaning possible
max. 2 g
SnCu 0.7
260° C / 10 s
Page 6 (10) 108-98009 Rev. C