408-10175 Datasheet, PDF (6/7 Pages) Tyco Electronics – Reasons for reissue are provided in Section 8, REVISION SUMMARY.

Heavy Head PIDG STRATO-THERM Crimping Heads
(Detail A) Inspection of Wire Barrel Crimping Dies
408-10175
(Detail B) Inspection of Insulation Crimping Dies
Wire Barrel Dies
Bottomed But Not
Under Pressure
Gage
Adjustment Pin
in No. 1
Position
Gage
Wire Barrel Dies
Bottomed But
Not Under Pressure
Insert 0.025 mm
[.001 In.] Shim Here
When Checking
CERTI-CRIMP Feature
GO gage must pass completely
through the die closure.
NO-GO gage may enter partially,
but must not pass completely
through the die closure.
Figure 6
8. REPLACEMENT AND REPAIR
Replaceable parts are listed in Figure 7. Parts other
than those listed in Figure 7 should be replaced by
Tyco Electronics to ensure quality and reliability of the
tool. Order replacement parts through your Tyco
Electronics Representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
For tool repair service, please contact an Tyco
Electronics Representative at 1–800–526–5136.
9. REVISION SUMMARY
S Updated document to corporate requirements
S Deleted text and changed wire size from 24–10
to 24–14 in Section 1, INTRODUCTION
S Deleted 12–10 wire information in tables in
Figures 2, 5, and 7
S Changed part numbers in table in Figure 7
6 of 7
Tyco Electronics Corporation
B Rev