408-10175 Datasheet, PDF (2/7 Pages) Tyco Electronics – Reasons for reissue are provided in Section 8, REVISION SUMMARY.

Heavy Head PIDG STRATO-THERM Crimping Heads
408-10175
3. INSTALLATION AND REMOVAL OF CRIMPING
HEADS
CAUTION
!
Do not operate the tool without the HHHT
adapter installed. Damage to the ram or seals
can result.
CAUTION
!
Do not operate the tool without a hand tool crimp
head installed. Damage to the adapter can result.
Battery Powered Crimp Tool Kit 1901235–[ ] with
HHHT Adapter comes with the HHHT adapter already
installed on the battery powered hand tool. The only
installation required is the installation of the crimping
heads.
DANGER
To avoid personal injury, be sure to exercise
extreme caution when handling the crimp tool.
Remove the battery before installing or removing
the crimping heads.
1. Remove the quick–release pins, described
above.
2. Insert the exposed portion of the crimp head
into the adapter cavity. See Figure 1.
3. Insert the two outer quick–release pins
through the holes in the adapter, and through
the holes in the links of the crimping head.
NOTE
i
The quick-release pins will snap" into position
when they are properly inserted.
4. Insert the center quick–release pin into the
adapter and through the holes in the ram and
the moveable die of the crimp head.
NOTE
i
The quick-release pin will snap" into position
when it is properly inserted.
3.1. Installation of Crimping Heads
As supplied, the adapter has three quick–release pins
installed (Figure 1). The two outer pins will be used to
secure the links of the crimp head (exposed portion of
the crimp head) to the adapter. The center pin will be
used to secure the movable die of the crimp head to
the ram of the adapter.
These pins must be removed prior to installing the
crimping head.
3.2. Removal of Crimping Heads
DANGER
To avoid personal injury, remove the battery
before removing the crimping heads.
To remove the crimping head, it will be necessary to
remove the quick–release pins and the crimp head
from the battery powered crimp tool.
HEAD
PART
NUMBER
WIRE
SIZE
(AWG)
DOT
CODE
1-576778-0
24-22
2 Dots
1-576779-0
20
1 Dot
1-576780-0
18
2 Dots
1-576781-0
16
1 Dot
1-576782-0
14
2 Dots
HANDLE COLOR
CODE
TERMINAL COLOR CODE
HIGH
TEMP.
LOW TEMP.
1 Handle Black
1 Handle Brown
Brown
Black
1 Handle Gray
1 Handle Purple
Gray
Purple
(With Black Stripe)
1 Handle Orange
1 Handle Black
Orange
Orange
(With Black Stripe)
2 Handles Orange
Orange
Orange
(With Black Stripe)
1 Handle White
1 Handle Black
White
Figure 2
White
(With Black Stripe)
STRIP LENGTH
Min.
Max.
5.56 [.219]
6.35 [.250]
5.56 [.219]
6.35 [.250]
5.56 [.219]
6.35 [.250]
5.56 [.219]
6.35 [.250]
5.56 [.219]
6.35 [.250]
2 of 7
Tyco Electronics Corporation
Rev B