|
408-8910 Datasheet, PDF (5/6 Pages) Tyco Electronics – Hydraulic Crimping | |||
|
◁ |
Hydraulic Crimping Head 1673672- 1
408- 8910
Suggested Plug Gage Design
GO Dimension
âBâ
Die Closure
Configuration
âAâ
âRâ
9.5 [.375] Min Typ
NO- GO Dimension
25.4
âRâ
[1.00]
Min Typ âBâ
DIE
BARREL CRIMP DIMENSIONS âAâ
SIZE
GO
N0- GO
8
2.11 [.083]
2.54 [.100]
6
3.12 [.123]
3.48 [.137]
4
4.04 [.159]
4.39 [.173]
2
4.83 [.190]
5.18 [.204]
GAGE MEMBER DIMENSIONS âBâ
GO
N0- GO
2.11 -- 2.12 [.0830 -- .0833]
2.51 -- 2.54 [.0990 -- .1000]
3.12 -- 3.13 [.1230 -- .1233] 3.477 -- 3.479 [.1369 -- .1370]
4.04 -- 4.05 [.1590 -- .1593] 4.391 -- 4.394 [.1729 -- .1730]
4.83 -- 4.84 [.1900 -- .1903]
5.17 -- 5.18 [.2039 -- .2040]
RADIUS âRâ
3.58 [.141]
3.96 [.156]
5.56 [.219]
6.35 [.250]
Figure 7
7.4. Crimping Head Check- Out Procedure
If the ram fails to return to the DOWN position after
completion of a crimping cycle, the cause may be in
the crimping head. To determine whether or not the
trouble is in the crimping head, release pressure in
the power unit. If the ram retracts, the trouble is not in
the crimping head. If ram does NOT retract, return
crimping head to Tyco Electronics for repair. See
Section 8, REPLACEMENT AND REPAIR.
8. REPLACEMENT AND REPAIR
necessary. Order replacement parts through your
Tyco Electronics Representative, or call
1--800--526--5142, or send a facsimile of your
purchase order to 1--717--986--7605, or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105--3608
Tools may also be returned for evaluation and repair.
For tool repair service, contact a Tyco Electronics
Representative at 1--800--526--5136.
Customer--replaceable parts are listed in Figure 9. A
complete inventory can be stocked and controlled to
prevent lost time when replacement of parts is
9. REVISION SUMMARY
S Updated document to corporate requirements
S Added ORIGINAL INSTRUCTIONS
Detail A
Detail B
âGOâ Gage Must Pass Completely
Through the Die Closure.
Indenter in Full
âUpâ Position
Plug Gage
Rev B
âNO- GOâ Gage May Enter Partially, but must not
Pass Completely Through the Die Closure.
Figure 8
Tyco Electronics Corporation
5 of 6
|
▷ |