|
408-4342 Datasheet, PDF (5/5 Pages) Tyco Electronics – Reason for revision can be found in Section 11, REVISION SUMMARY. | |||
|
◁ |
PRO-CRIMPER III Hand Crimping Tool Assembly 58603-1
408-4342
Screwdriver
Ratchet
Adjustment
Wheel
Lockscrew
(Typ)
10. REPLACEMENT
Customerâreplaceable parts are shown in Figure 1.
Available separately, PROâCRIMPER III Hand
Crimping Tool Repair Kit 679221â1 includes a
replacement nut and a variety of pins, rings, screws,
and springs.
If the dies are damaged or worn excessively, they
must be replaced.
Order the repair kit and replaceable parts through
your Tyco Electronics representative, or call
1â800â526â5142, or send a facsimile of your
purchase order to 717â986â7605, or write to:
CUSTOMER SERVICE (38â35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105â3608
Figure 5
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened,
chipped, worn, or broken areas. If damage or
abnormal wear is evident, the tool must be replaced.
See Section 10, REPLACEMENT.
11.REVISION SUMMARY
Since the previous release of this instruction sheet,
the following changes have been made:
S PROâCRIMPER II Hand Tool became the
PROâCRIMPER III Hand Tool;
S The TE logo was applied; and
S The format was updated to the current
corporate requirements.
Rev A
Tyco Electronics Corporation
5 of 5
|