English
Language : 

408-4342 Datasheet, PDF (1/5 Pages) Tyco Electronics – Reason for revision can be found in Section 11, REVISION SUMMARY.
PRO-CRIMPER* III Hand Crimping
Tool Assembly 58603-1 with
Die Assembly 58603-2
Instruction Sheet
408-4342
21 MAY 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Die Assembly
Moving Jaw
Ratchet Adjustment Wheel
Stationary Jaw
Back of Tool
(Wire Side)
Tool Marking (1)
Pivot Pin
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
The PRO-CRIMPER III Hand Crimping Tool is a Commercial" grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in the
appropriate 114 application specification, but may not comply with other feature
parameters of the specification. Tyco Electronics offers a variety of tools to
satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1-800-722-1111.
Stationary Handle
Moving Handle
TE Die Assembly
{ TE Locator Assembly
} Contact FamilY
Size (mm2)
(Color)
Wire
Insul Dia
(mm [in.])
Strip Length
(mm [in.])
2.5
(Yellow)
58603-2
58516-1
Junior Power
Timer and
2.8mm Tab
1.5
(Blue)
1.0
(Red)
1.4-2.1
[.055-.083]
3.1-3.9
[.122-.154]
0.75
(Green)
{}
Supplied with die assembly, also available separately.
Contact the Tooling Assistance Center or the Product Information Center at the numbers listed below for specific contact part numbers.
Figure 1
1. INTRODUCTION
PRO–CRIMPER III Hand Crimping Tool Assembly
58603–1 consists of Die Assembly 58603–2 and
PRO–CRIMPER III Hand Tool Frame 354940–1. The
die assembly consists of crimping dies and a locator
assembly.
Read these instructions thoroughly before crimping
any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reason for revision can be found in Section 11,
REVISION SUMMARY.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B