|
643424-1 Datasheet, PDF (4/6 Pages) Tyco Electronics – 2-Piece Power Connectors | |||
|
◁ |
TE Connectivity
Application: Cable Power
2-Piece Power Connectors
CABLE POWER
Products
MULTI-BEAM XLE
ET POWER
RAPID LOCK
High Current Universal
MATE-N-LOK
AMP Power Series
Wave Crimp
Wire Size
26-8 AWG
14-10 AWG
12-0 AWG
30-10 AWG
300MCM-0 AWG
Flat Cable
Current Rating
up to 50 Amps
up to 35 Amps
50-250 Amps
up to 35 Amps
15-275 Amps
40-110 Amps
Specialty
Low, high power options in
same connector
Low profile
BusBar Quick Connect/
Disconnect
Panel mount or
free hanging versions
Single & 2 pole
Quick Connect/Disconnect
Flat
te.com/products/multibeamxle
MULTI-BEAM XLE Cable Receptacles
⢠X, Y, Z float mount, blind-mate
connectors for drawer type applications
⢠Allows more angular misalignment than
the original MULTI-BEAM XL connector
⢠Modular design to meet any
application
⢠Hot-Pluggable
⢠Panel Mount, Slide-to-Lock and
Squeeze-to-Release configurations are
available
te.com/products/wavecrimp
AMPOWER Wave Crimp System
⢠Flat cable, dissipates heat better than
round wire
⢠Termination of flat cable requires
no stripping. Provides a reliable low
resistance, gas tight interface
⢠Lower operating temperature than
standard round/discrete wires
⢠Easily formed into shape, without
cable ties
⢠Lower cost than laminated bus bars
te.com/products/amppowerseries
AMP Power Series Connectors
⢠Single pole and 2-pole connector
housings, crimp snap-in contacts, and
accessories
⢠Rugged contact design
⢠Open barrel contacts 6-20AWG on
reels for automatic and semiautomatic
machine termination
⢠Compatible with industry alternate
standard versions
te.com/products/universalmatenlok
High Current Universal MATE-N-LOK II
Connectors
⢠Available in 2-15 circuit sizes for free
hanging, panel mount, or wire-to-board
connection
⢠Louvertac band and screw machined
contacts provide very high current with
low contact resistance
⢠No extraction tools required/economical
⢠Pin and sockets can be intermixed in
the same housing
te.com/products/rapidlock
RAPID LOCK Bus Bar Connectors
⢠Locking feature retains each contact to
mating pin
⢠No installation tools required
⢠Fast, reliable replacement for power
lugs
⢠Up to 250 Amps per contact; very low
contact resistance
te.com/products/etpower
ET Power Connector
⢠Up to 35Amps per contact
⢠End-to-end stackability
⢠Low profile, less than 8 mm above PCB
⢠Cable-to-PCB applications
⢠Positive latch retention
⢠Right angle and vertical mounts
te.com/powerconnectors
|
▷ |