408-9910 Datasheet, PDF (4/4 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY.

Seating Tools 58511-[ ]
408-9910
5. TOOL INSPECTION
Each seating tool is assembled and inspected before
shipment. We recommend that the tool be inspected
immediately upon arrival at your plant to assure that it
has not been damaged during shipment.
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the tool or be supplied to
supervisory personnel responsible for the tool. The
inspection frequency should be based on the amount
of use, working conditions, operator training and skill,
and established company standards.
6. MAINTENANCE
7. REPLACEMENT AND REPAIR
The parts listed in Figure 1 are customer–
replaceable. A complete inventory can be stocked
and controlled to prevent lost time when replacement
of parts is necessary. Order replacement parts
through your Tyco Electronics Representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG PA 17105–3608
Tools may be returned to Tyco Electronics for
evaluation and repair. For tool repair service, contact
a Tyco Electronics Representative at
1–800–526–5136.
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint–free cloth. Do NOT
use objects that could damage the tool.
8. REVISION SUMMARY
Since the previous release of this sheet, the following
changes were made:
S Updated document to corporate requirements
S Added new information for part number
2–58511–2 in table in Figure 2
2. Ensure that the screws are in place and
secured.
3. When the tool is not in use, store it in a clean,
dry area.
4 of 4
Tyco Electronics Corporation
Rev F