408-9607 Datasheet, PDF (4/5 Pages) Tyco Electronics – Feed- Through Head Assembly

Feed- Through Head Assembly 58443- 1
408- 9607
1. Remove dust, moisture, and other contaminants
with a clean brush, or soft, lint--free cloth. DO NOT
use objects that could damage the head.
2. Make sure all components are in place and
properly secured.
3. Actuate the tool to ensure mechanisms inside
the head move smoothly.
6.2. Quality Control Maintenance
Regular inspections should be performed by your
quality control personnel. A record of quality control
inspections should remain with the personnel
responsible for the head. One inspection a month is
recommended; however, operator skill, amount of
use, ambient working conditions, and your company’s
established standards are all factors in establishing
frequency of inspections.
1. Remove any accumulated film with a suitable
cleaning agent that will NOT affect plastic material.
2. Make sure all components are in place and are
properly secured.
3. Make a few test terminations, and inspect the
termination in accordance with Section 5.
4. Check for chipped, cracked, worn, or broken
areas. If damage is evident, repair is necessary.
See Section 7.
7. REPLACEMENT AND REPAIR
Customer--replaceable parts are listed in Figure 5.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by TE to ensure quality and
reliability. Order replacement parts
17
16
14
13 12
A
A
15
18
23 4
1
Section A- A
5
6 7 8 9 10 11
4 of 5
Figure 5 (Cont’d)
Tyco Electronics Corporation
Rev C