408-8022 Datasheet, PDF (4/4 Pages) Tyco Electronics – Read the following instructions carefully before and during the installation of the conversion kits on the machine.

Conversion Kits 690675-2 and 692613-1
408-8022
Figure 3
4. INSTALLATION AND REMOVAL OF
MINIATURE APPLICATOR
CAUTION
!
MAKE CERTAIN that electrical power to the
machine is OFF by pulling the plug from the
receptacle.
1. Install the movable stop on the back of the base
mount for the end feed applicator or on the left end
for the side feed applicator, as shown in Figure 2.
2. Place the applicator on the base mount, insert
the ram post in the machine ram, then slide the
applicator into position against the stops.
3. Secure the applicator with the hold–down
bracket and two screws supplied in the kit. The
location of the hold–down bracket differs for end
feed and side feed applicators. Make certain the
bracket is located correctly.
4. Load the applicator in accordance with the
applicator instruction sheet supplied with the
applicator.
5. Set the wire disc and insulation disc for the wire
gage to be used in accordance with the data plate
on the applicator and/or the applicator parts list
supplied with the applicator.
6. Adjust the base mount for the correct crimp
height in accordance with the machine manual.
7. Install the side feed or end feed shroud and
guard assembly, for the type of applicator installed,
as shown in Figure 2.
8. To remove the applicator from the machine,
unload the applicator tooling according to the
instruction sheet shipped with the applicator,
remove the hold–down bracket, and slide the
applicator away from the stops on the base mount
until the ram post is clear of the machine ram.
5. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to current requirements
S New format
4 of 4
Tyco Electronics Corporation
Rev A