408-4260 Datasheet, PDF (4/7 Pages) Tyco Electronics – Mass Termination Assembly

MTA 58575- 1 and 58576- 1
408- 4260
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Guide
(2 Places)
Insertion
Tooling
Insertion- Depth
Adjustment Slot
Cylinder
Air Hose
Handle
Safety Latch
(2 Places)
Trigger
Safety Latch
Adjustment
Screw (2 Places)
Specifications:
Weight.........1.3 kg [2.8 lb]
Noise...........80 dBA Max
Vibration......Less than 2.5 mm/s²
MTA APPLICATOR
ASSEMBLY
58575--1
58576--1
CONNECTOR- HOLDING
FIXTURE
58242--3
58243--3
59845--3
58009--2
58010--2
58244--3
58245--3
59847--3
59848--3
59849--3
MTA CONNECTOR
.100 Closed End Receptacle With or Without Polarization Tabs
.100 Feed--Through Receptacle With or Without Polarization Tabs
.100 Feed--Through Receptacle Without Polarization Tabs
.156 Closed End Posted Receptacle
.156 Feed--Through Posted Receptacle
.156 Closed End Test Receptacle With or Without Polarization Tabs
.156 Feed--Through Test Receptacle With or Without Polarization Tabs
.156 Feed--Through Receptacle
.156 Closed End Card Edge Receptacle
.156 Feed--Through Card Edge Receptacle
Figure 1
1. INTRODUCTION
Mass Termination Assembly (MTA) Applicator
Assemblies 58575--1 and 58576--1 are used with
connector--holding fixtures listed in Figure 1 to insert
wires into MTA .100 and .156 closed end and
feed--through connectors.
For information regarding connector--holding fixtures,
refer to Instruction Sheet 408--7994 (MTA .100) and
408--7995 (MTA .156). Read these instructions and
referenced material thoroughly before using the
applicator assembly.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are for reference only and are not drawn
to scale.
The date code is marked on the body of the tool. The
date code is in the format YYWW, where YY
represents the year of manufacture and WW
represents the week of manufacture. For example, if
the date code marked on a tool is 0533, the tool was
made in the 33rd week of 2005.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
4 of 7
Tyco Electronics Corporation
Rev D