408-1311 Datasheet, PDF (4/7 Pages) Tyco Electronics – Pneumatic crimping heads listed in Figure 1 are designed for use in Pneumatic Tool

Pneumatic Crimping Heads for Use with Pneumatic Tool 69015
408-1311
ACCEPT
3
1
REJECT
Terminal
1
4
3
2
Wire Range
Stamped Here
3
4
2
Wire Range
Stamped Here
1
4
1
4
Wire Range
2
Stamped Here
Flag Terminal
4
1
Wire Range
2
Stamped Here
2
4
3
1
Wire Range
Stamped Here
4
Parallel
Splice
5
4
1
4
1
3
3
3
6
Butt Splice
5
2
Wire Range
Stamped Here
1
Crimp centered on wire barrel. Crimp may be off
center BUT NOT OFF END OF WIRE BARREL.
2
Wire size being used matches wire size stamped on
terminal or splice and crimping head.
3
Wire insulation does not enter wire barrel.
Wire is visible through inspection window of butt splice.
4
Wire is flush with or extends slightly beyond end of
terminal wire barrel.
On parallel splices, bare wire ends must be flush with or
extend slightly beyond end of barrel.
1
Crimp off end of splice or terminal wire barrel.
2
Wire size being used does not match wire size
stamped on terminal or splice and crimping head.
3
Wire insulation entered wire barrel of terminal or splice.
CHECK FOR INCORRECT STRIP LENGTH.
4
Wire not inserted far enough into terminal or splice.
End of wire must be visible through inspection window
of butt splices, and be flush with or extend slightly
beyond end of terminal wire barrel or parallel splice.
5
Excessive flash" on terminal or splice indicates
wrong wire, terminal or splice, or tooling combination
was used.
6
Nicked or missing strands.
Figure 5
4 of 7
Tyco Electronics Corporation
Rev G