408-1311 Datasheet, PDF (1/7 Pages) Tyco Electronics – Pneumatic crimping heads listed in Figure 1 are designed for use in Pneumatic Tool

Upper Jaw
Lower Jaw
Pneumatic Crimping Heads for
Use with Pneumatic Tool 69015
Toggle
Lever
Pneumatic Tool
69015 (Ref)
Crimping Heads
48172, 48173, 48174,
48183, 48412, 48413,
48414, 48415, 48416,
49956
Link (2 Places)
Mounting
Lugs
Toggle Arm
Release
Lever
Instruction Sheet
408-1311
04 MAY 09 Rev G
Assembly
Pins
Thumb
Control
Figure 1
1. INTRODUCTION
Pneumatic crimping heads listed in Figure 1 are
designed for use in Pneumatic Tool 69015. The
heads, when installed in the tool, will crimp
SOLISTRAND* terminals and splices and
STRATO–THERM* heat–resistant uninsulated
terminals onto solid or stranded copper wire sizes 8
through 1/0 AWG. Refer to Figure 2 for types of
terminals and splices and applicable crimping heads.
Read these instructions thoroughly before using the
crimping head.
NOTE
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
position the head in the tool and to control the
opening and closing of the crimping jaws when the
tool is actuated (refer to Figure 1).
3. CRIMPING PROCEDURE
Install the appropriate crimping head onto the tool
according to Instruction Sheet 408–1310. Refer to
Figure 2, and select the appropriate terminal or splice
and wire. Ensure that the wire size stamped on
terminal or splice corresponds with the wire size
stamped on the link of the crimping head.
i
Figures and illustrations are for reference only
and are not drawn to scale.
For information regarding head insertion and removal
and general operation of the pneumatic tool, refer to
Instruction Sheet 408–1310.
NOTE
i
For product part numbers, refer to Catalog 65505
for SOLISTRAND terminals and splices, and
Catalog 82011 for STRATO-THERM
heat-resistant uninsulated terminals.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
Strip the wire to the length indicated in Figure 2. Do
NOT cut or nick the wire. Then proceed as follows:
2. DESCRIPTION
Each crimping head features an upper and lower
crimping jaw linked to a toggle lever which is used to
1. Insert stripped wire into terminal or splice until
end of wire is flush with or extended slightly
beyond end of wire barrel, or until wire butts
against wire stop.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 7
LOC B