408-9515 Datasheet, PDF (3/5 Pages) Tyco Electronics – Ribbon Cable Notcher

Ribbon Cable Notcher 854449- [ ]
Orientation of Ribbon Cable Notcher for
End Notching
408- 9515
Manual Arbor
Frame (Ref)
Cable Support
Plate
Cable Support
Plate
Only Orientation of
Ribbon Cable Notcher
for Feed- Through
Notching
Figure 3
4.1. Installation
1. Raise the ram to the top of its stroke.
2. Remove the four socket head cap screws from
the underside of the notcher.
3. Place the notcher on the base of the frame,
oriented according to type of notching. Refer to
Figure 3. Install the four socket head cap screws
onto the notcher from the underside of the frame.
4. Set the ram height on the frame: 69.8 [2.75] for
end notching or 65.8 [2.59] for feed--through
notching. For procedure, follow the instructions
included with the frame.
4.2. Removal
1. Remove the four socket head screws from the
underside of the notcher.
2. Slide the notcher out from the base of the
frame.
5. OPERATION
CAUTION
!
To avoid personal injury, make sure that the
guard is in place when operating the notcher.
5.1. End Notching
CAUTION
!
Make sure that the ram height is set at
69.8 [2.75].
1. Loosen the two socket head screws securing
the cable stop plate, and locate the cable stop
plate against the dowel posts. Tighten the screws.
2. Place the cable on the cable support plate, and
align the cable with the flutes of the plate.
3. Slightly press down on the cable (to keep the
cable aligned with the flutes in the plate), and slide
the cable into the notcher until it butts against the
cable stop plate. Refer to Figure 4.
Slightly Press Down
on Cable
Flutes in Cable
Support Plate
Figure 4
4. Cycle the power unit.
5. Remove notched end of cable by pulling the
cable straight back and out of the notcher.
6. Refer to Figure 5, and inspect the cable
according to the specifications listed in Figure 1.
5.2. Feed- Through Notching
CAUTION
!
Make sure that the ram height is set at
65.8 [2.59].
Rev C
Tyco Electronics Corporation
3 of 5