408-8810 Datasheet, PDF (3/3 Pages) Tyco Electronics – Read and understand these instructions before using the seating tool.

Seating Tools 91377-1 and 91378-1
408-8810
6. Check the connector for proper seating
according to the following:
a. the widest section of each contact is inside its
intended pc board hole
b. the connector is seated on the pc board with
the seating height—measured from the top of
the connector to the top of the pc board—given
in Figure 2
c. if present, the gap between the housing and
the pc board is no more than 0.10 mm [.004 in.]
NOTE
i
For detailed application requirements of the
connector, refer to Application Specification
114-13059.
6. MAINTENANCE AND INSPECTION
6.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint–free cloth. DO NOT
use objects that could damage the tool.
2. When the tool is not in use, store it in a clean,
dry area.
6.2. Periodic Inspection
It is recommended that the tool be inspected, using
Figure 3, immediately upon its arrival to ensure that it
has not been damaged during shipment.
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the tool or be supplied to
personnel responsible for the tool. The inspection
frequency should be based on the amount of use,
working conditions, operator training and skill, and
established company standards.
Note: Dimensions are in millimeters with inches in brackets.
Tool 91377-1
 9.65 [.38] 45_
22.35
[.88]
20.32
[.800]
5.54 [.218]
(2 Places)
 0.76 [.03] 45_
(2 Places)
25.65+0.25/-0.00
[1.010+.010/-.000]
38.6 [1.44]
Tool 91378-1
 9.65 [.38] 45_
22.35
[.88]
20.32
[.800]
0.51
[.020]
1.57 [.062]
(2 Places)
34.92 [1.375]
38.1 [1.500]
Front View
(Tools 91377-1 and 91378-1)
15.24
[.600]
7. REPLACEMENT
Order additional tools through your representative, or
call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
24.89 [.980]
Figure 3
8. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
Rev B
Tyco Electronics Corporation
3 of 3