|
408-6775 Datasheet, PDF (3/4 Pages) Tyco Electronics – Install dies according to the instructions packaged with the tooling. | |||
|
◁ |
Suggested Plug Gage Design
GO
Diameter
NO-GO
Diameter
Center Contact
Die Closure Configuration
W
Ferrule
Die Closure Configuration
Crimping
Chamber
Gage Element Diameter
GO
NO-GO
âWâ Width
(Max)
Center
Contact
0.940-0.947 1.013-1.016
[.0370-.0373] [.0399-.0400]
--
Ferrule
3.200-3.208 3.325-3.327
[.1260-.1263] [.1309-.1310]
1.52 [.060]
Inspection of Crimping Chamber
Crimping
Chamber
408-6775
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, please contact an Tyco
Electronics representative at 1â800â526â5136.
6. REVISION SUMMARY
Since the previous release of this instruction sheet,
the following revisions have been made:
⢠TE logo was applied;
⢠Figure 4 was updated; and
⢠Document format was updated to the current
corporate requirements.
GO element must pass
completely through the
crimping chamber.
NO-GO element may enter
partially, but must not pass
completely through the
crimping chamber.
Figure 4
For additional information regarding the use of a plug
gage, refer to 408â7424.
5. REPLACEMENT AND REPAIR
Customerâreplaceable parts are listed in Figure 5.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics to ensure
quality and reliability. Order replacement parts
through your Tyco Electronics representative, or call
1â800â526â5142, or send a facsimile of your
purchase order to 717â986â7605, or write to:
Rev B
Tyco Electronics Corporation
3 of 4
|
▷ |