408-4093 Datasheet, PDF (3/4 Pages) Tyco Electronics – PRO–CRIMPER III Hand Tool

PRO-CRIMPER III Hand Tool Assembly58560-1
408-4093
Insulation
Stuffer
Contact
Stuffer
Modular Plug
Connector
(Cutaway View)
Crimp Height
Dimension
6.02 + 0.13
[.237 + .005]
Cable
Modular Plug
Connector
Housing
Support
Figure 3
Conductor Location
0.64 [.025] Max
Inspect connector for proper crimp height using an
indicator with needle–point probes. Refer to Figure 3
for correct crimp height measurement. If necessary,
adjust the crimp height as described in Section 6,
CRIMP HEIGHT ADJUSTMENT.
6. CRIMP HEIGHT ADJUSTMENT (Figure 4)
1. Remove the lockscrew from the ratchet
adjustment wheel.
7. MAINTENANCE AND INSPECTION
7.1. Daily Maintenance
Tyco Electronics recommends that operators of the
tool be made aware of, and responsible for, the
following steps of daily maintenance:
1. Remove dust, moisture, and any other
contaminants from the tool with a clean, soft brush,
or a clean, soft, lint–free cloth. Do NOT use hard or
abrasive objects that could damage the tool.
2. With a screwdriver, adjust the ratchet wheel
from the opposite side of the tool.
Screwdriver
3. Observe the ratchet adjustment wheel; if a
tighter crimp is required, rotate the adjustment
wheel COUNTERCLOCKWISE to a
higher–numbered setting. If a looser crimp is
required, rotate adjustment wheel CLOCKWISE to
a lower–numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the dimension is acceptable, secure the
lockscrew. If the dimension is unacceptable,
continue to adjust the ratchet, and again measure
a sample crimp.
If correct crimp height cannot be obtained, tool and or
dies must be replaced See Section 8, PARTS
REPLACEMENT.
Ratchet
Adjustment
Wheel
Lockscrew
(Typ)
Figure 4
Rev A
Tyco Electronics Corporation
3 of 4