408-10366 Datasheet, PDF (3/3 Pages) Tyco Electronics – The Electro--Hydraulic Hand Tool and specific DAHT head assemblies must be ordered separately.

Electro- Hydraulic Hand Tool Adapter Assembly 2119483- 1
408- 10366
5. Remove the terminated wire.
NOTE
i
To abort a crimp,press the pressure release
device on the power tool. Information on the
pressure release device is contained in
409- 10095, Section 6, PRESSURE
RELEASE/RESET TOOL.
5. PREVENTIVE MAINTENANCE
DANGER
To avoid personal injury, be sure to exercise
extreme caution when handling the
Electro- Hydraulic Hand Tool. Remove the power
source ( and release hydraulic pressure if
applicable - - see 409- 10095) before performing
maintenance.
5.1. Daily Maintenance
Perform the following maintenance on a daily basis:
1. Inspect the dies for wear or damage such as
cracks, gouges or chips. If damage is found, return
the DAHT tool head to Tyco Electronics for
inspection.
2. Clean the tooling, removing accumulations of
dirt and grease on the adapter – particularly:
a. in areas where contacts are crimped, and
b. in the area where the DAHT head connects
to the adapter assembly.
3. Wipe the tooling with a soft, lint--free cloth.
5.2. Yearly Maintenance
Once a year or every 10,000 cycles (whichever
comes first) return the DAHT tool crimp head to Tyco
Electronics for inspection.
6. REPLACEMENT AND REPAIR
DANGER
To avoid personal injury, be sure to exercise
extreme caution when handling the
Electro- Hydraulic Hand Tool. Remove the power
source (and release hydraulic pressure,if
applicable - - see 409- 10095) before replacing or
repairing components .
Replacement parts are identified in Figure 1 and the
table in Figure 2. The recommended spares should
be stocked for immediate replacement. Order
replacement parts (or return parts) through your
Tyco Electronics Representative, or call
1--800--526--5142, or send a facsimile of your
purchase order to 717--986--7605. Or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
For repair services, call the Tooling Assistance Center
at 1--800--722--1111.
For spare parts, refer to the table in Figure 2:
Spare Parts
TE Part Number
Description
Qty.
18023--1
Head Retaining Screw
1
217873--3
Quick Pin
2
2063866--1
Pinch Caution Label
1
Figure 2
7. RoHS INFORMATION
Information on the presence and location of any
substances subject to RoHS (Restriction on
Hazardous Substances) can be found at the following
website:
http://www.tycoelectronics.com/customersupport/rohs
supportcenter/
Click on “Find Compliance Status” and enter
equipment part number.
8. REVISION SUMMARY
S Initial release of document
Rev A
Tyco Electronics Corporation
3 of 3