4-1734598-5 Datasheet, PDF (3/4 Pages) Tyco Electronics – Wire To Board Serial, Pitch 1.25mm

108-57273
Test Item
Requirement
Procedure
Mechanical Requirement
Subject mated connectors to 10-55-10
No electrical discontinuity greater Hz traversed in 1 minute at 1.52mm
9
Vibration
than 1 microsecond shall occur. amplitude 2 Hours each of 3 mutually
See note.
perpendicular planes, passing DC 1mA
current during the test.
Accelerate Velocity: 490m/s² 50G
Waveform: Half-sine shock plus
No electrical discontinuity greater Duration: 11msec
10
Physical Shock
than 1 microsecond shall occur. No. of Drops : 3 drops each to normal
See note.
and reversed directions of X,Y and Z
axes, totally 18 drops, passing DC 1mA
current during the test.
Environmental Requirements
11
Temperature Life
(Heat Aging)
See note.
Mated Connector
85C°, 250 hours
Mated Connector
12
Thermal Shock
See note.
-55+/-3C° (30 minutes),
+85+/-2C° (30 minutes)
Making this a cycle, repeat 5 cycles
Mated Connector
13 Humidity-Temperature Cycle See note.
25 – 65C°, 95% R.H., 10 cycles
(See Figure 2)
Subject mated connectors to 35+/-2C°
and 5+/-1% salt condition for 48 hours.
14
Salt Spray
See note.
After test, rinse the sample with water
and recondition the room temperature
for 1 hour.
Steam Aging Preconditioning:
The inspected area of each lead 93°C +3/-5°C, 8 hours ±15 min.
Solderability
must have 95% solder coverage Reflow Temperature: 230 - 245°C
15
minimum.
Reflow Time: 50 - 70 s.
JESD22-B102D, Condition C
Moisture Soak Preconditioning:
85°C and 85% RH. for 168 hours.
16
Resistance to Reflow
Soldering Heat
See note.
Preheat Temp.: 150 – 200°C, 60 – 180 s.
Time over liquidus (217°C): 60 – 150 s.
Peak Temp.: 260 +0/-5°C, 20 – 40 s.
Duration: 3 cycles.
Tyco spec. 109-201, Condition B
NOTE Shall meet visual requirements, show no physical damage, and meet requirements of additional tests
as specified in the Product Qualification and Rrequalification Test Sequence shown in Figure 2.
Figure 1 (end)
Rev C
3 of 4