4-1734598-5 Datasheet, PDF (2/4 Pages) Tyco Electronics – Wire To Board Serial, Pitch 1.25mm

108-57273
C. Temperature: -25 °C to 85°C
3.4. PERFOMANCE AND TEST DESCRIPTION
The product is designed to meet the electrical, mechanical and environmental performance requirements
specified in Figure 1 unless otherwise specified. All tests are performed at ambient environmental
conditions per AMP Specification 109-1
3.5. TEST REQUIREMENTS AND PROCEDURES SUMMARY
Test Item
Requirement
1
Examination of Product
Meets requirements of product
drawing. No physical damage.
Electrical Requirement
Procedure
Visual inspection
2 Termination Resistance 20 m: Max
Subject mated contacts assembled in
housing to 20mV Max open circuit at
10mA Max.
3
Insulation Resistance
1000 M: Min. (Initial)
100 M: Min. (Finial)
Impressed voltage 500 VDC
Test between adjacent circuits and
contact
4
Dielectric withstanding
Voltage
No creeping discharge nor
flashover shall occur.
Current leakage: 0.5 mA MAX
500 VAC for 1minute
Test between adjacent circuits and
contact
Contact series-wired, apply test current
of loaded rating current to the circuit,
5
Temperature Rising
30C° Max. under loaded rating
current
and measure the temperature rising by
probing on soldered areas of contacts,
after the temperature becomes
stabilized deduct ambient temperature
from the measured value.
Mechanical Requirement
6 Connector Mating Force 1 kgf/pin Max.
7 Connector Unmating Force 0.1 kgf/pin Min.
Operation Speed: 10 mm/min.
Measure the force required to mate
connector
Operation Speed: 10 mm/min.
Measure the force required to unmate
connector
8
Durability
See note.
Operation Speed: 10 cycle/min.
No. of Cycles: 25 Cycles
Figure 1 (cont.)
Rev C
2 of 4