408-9514 Datasheet, PDF (2/2 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 5, REVISION SUMMARY

Extraction Tool 844751-1
Detail A
Tool Tip Between Terminal
and Connector Locking Lance
Mating Face
of Connector
Detail B
Connector Locking
Lance Released from
Terminal
408-9514
Tool Stop Against
Connector
Push Tool and Tilt Tip Away
From Locking Feature
Figure 3
Simultaneously
Pull Wire
CAUTION
!
DO NOT use excessive force when extracting a
terminal from its cavity. If there is difficulty in
removing the terminal, re-insert the tool tip,
making sure the tip is properly positioned in the
cavity; then repeat Steps 3 and 4.
4. INSPECTION AND REPLACEMENT
It is recommended that the tool be inspected
immediately upon arrival at your facility to ensure that
the tool has not been damaged during shipment and
that the tool conforms to the dimensions provided in
Figure 4.
Order replacement tools through your representative,
or call 1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
5. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S Removed superceded terminal part number
11.18 [.44]
76.2 [3.0]
31.8 [1.25]
8.89+0.51/-0.25
[.35+.02/-.01]
Figure 4
2 of 2
Tyco Electronics Corporation
Rev A